Jenn-Air Microwave Parts

We found the parts on this website. Thanks to your search bar, we could see if the parts would work on our model microwave. Read more

When the new bulb didn't want to go in, I felt around and realized the base of the old bulb was still in there. With some effort I got it out and new bulb in, Light cover fit fine, but did not come with a screw to hold it in. That would have been helpful. Read more

• Won't start

First, it was going to cost $95 for an appliance guy just to look at it! I figured there would be an upcharge on the parts + labor on top of the $95, so I took a chance & decided my husband & I could fix it cheaper; we were right, but it was a 3 week process (luckily, we have another microwave in the basement we were able to use in the meantime). I googled the microwave model #, then price checked the same item I thought we needed; printed off the diagrams of the various microwave "systems" &... Read more

• Won't start

I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more

• Won't start

Watched u-tube Read more

I took the machine screws out of the outer panel for the right side only. Then pull the panel back a bit to release the lips from the front of the machine and had immediate access to the internal assembly that housed mounting nut. Order the new parts from AppliancePartsPro.com during the Thanksgiving week. Still received via FedEx in short time due to their same day shipping - which was greatly appreciated and surprising. Most small part places take a while to get the product out the door,... Read more

This time, before mounting the Grill-Vent I covered the mounting points and surrounding areas with heat resistant aluminium tape in the hope that it would create a heat barrier so the mounting points would not crumble so quickly. Read more

Ordered what was shown on the pc. I removed old ones, put in new ones good to go. Read more

I attempted to diagnose the four thermostats/thermal switches in the microwave....two right behind the control panel, one on top of the cooking cabin, and one under a metal shroud above the magnetron. While checking continuity with a voltmeter, i questioned one of them behind the control panel and the one above the magnetron. I then noticed a burn mark on the plastic connector sleeve for the one above the magnetron. I took a scrap piece of 14 gage copper wire and beat the ends flat with a... Read more

Replace fuse .latches and grille support kit Read more

I ordered a new magnetron and a new capacitor and after they arrived I set to work. I took plenty of pictures with my phone to remind me how the components came apart but it was pretty straight forward. Once the new parts were in and everything was reassembled the microwave worked good as new. The repair was less than a third the cost of replacement and no special tools are required. Just be careful to discharge the capacitor. This website is a great resource. Read more

Ordered small piece and put it in Read more

• Won't start

In addition to blown fuse; the fuse holder was melted at one end. Checked the unit to see if any part or wiring that would cause the issue, none was visible. Referred to wiring diagram included inside to identify components, including interlocks. All seemed functional. Bought replacement 20A fuse. Fuse holder no longer available so bought similar unit with 25A rating - little retrofitting. Put unit back together, and it's working so far. Wife is happy. Read more

I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read more