Kelvinator Parts

Replacement door trim kit with corner breaker for freezers. Installs around door edges to provide finished appearance. Needed when original trim is cracked, broken, or missing.

This replacement tube routes water from the refrigerator's defrost area to the drain pan to help prevent leaks and pooling. A simple, direct-fit part for restoring proper drain flow and reducing water buildup. What it does

• Channels defrost and condensation water to the drain pan to prevent interior pooling.
• Helps maintain normal drainage to avoid ice buildup or water leaks.
• Restores a damaged, cracked or clogged original tube where flow is restricted.
• Works as a service part when inspecting drain path during defrost/drain issues.

• One replacement tube.

• Disconnect power to the appliance before starting any repair.
• Remove access panels as needed and route tube along the factory path; avoid sharp bends or kinks.
• Inspect drain openings and heater components while replacing the tube.

This outer refrigerator door restores the appliance's exterior and helps maintain proper sealing and temperature control. It replaces a cracked, dented, or damaged door to improve appearance and function. What it does

• Replaces a damaged outer door panel so the fridge can close properly and look like new
• Helps maintain an effective seal when used with an intact gasket, reducing cold air loss
• Stops drafts and visible damage that can lead to higher energy use or interior moisture
• Works with existing hinges and trim when the correct hardware is transferred

• Disconnect power to the appliance before starting and remove food from door shelves as needed
• Transfer existing hinge assemblies, handles, trim, and gasket to the new door unless this part specifically includes them
• Use caution when lifting and aligning the door to avoid chipping paint or damaging the hinge pins
• If you see missing or damaged hardware, get the required screws/hinges separately.

Black button plug that covers upper hinge mounting holes on your refrigerator. Replace if original plug is missing, cracked, or broken for a clean finish.

White outer door panel for chest freezers. Replaces cracked, damaged, or discolored exterior lid panels. Restores appearance and structural integrity.

Plastic plug insert for freezer door base. Covers screw holes or mounting points. Replace if cracked, missing, or worn to restore a clean appearance.

Rubber mounting grommet that cushions and isolates the compressor from the chassis. Replace if cracked, worn, or missing to restore proper support.

The refrigerator door tilt-out shelf end cap covers and secures the left end of adjustable door storage bins that tilt forward for easy access. Replace when the end cap cracks, breaks, or no longer securely holds the shelf in position.

Secures interior trim and panels in your refrigerator. Replace when trim becomes loose or rattles. Verify fit with your model number before ordering.

Freezer won't cool or runs constantly? This temperature control thermostat regulates cooling cycles to maintain set temperature. Moderate DIY repair.

Hinge-side door stop that limits door travel and protects the hinge assembly. Replaces a cracked, broken, or missing stopper to restore proper alignment.

Fix unresponsive controls or erratic temperature regulation. This main circuit board manages compressor, defrost cycles, and user settings in freezers.

Black upper hinge cover conceals and protects your refrigerator's door hinge assembly. Replace if cracked, broken, or missing to restore appearance.