Kelvinator Parts

This bottom hinge replaces the lower door pivot on compatible Frigidaire refrigerators to restore proper door alignment and smooth opening. It provides a secure pivot point to help maintain an even close and consistent seal. What it does:

• Supports and pivots the lower edge of the refrigerator door for smooth opening and closing.
• Helps maintain correct door alignment so the gasket seals evenly.
• Common replacement for doors that sag, bind, or do not close evenly.
• Works with the factory mounting hardware and hinge locations on compatible models.

• Disconnect power and remove food and loose items from the door before starting.
• Always support the door while removing or installing the hinge to prevent injury or damage.
• Use appropriate hand tools and avoid overtightening fasteners; check door alignment after installation.
• Refer to your model's service manual or official parts diagram for model-specific steps and torque specs.

Protective cover that shields the range door hinge assembly from debris and damage. Replace if cracked, broken, or missing to restore a clean finished look.

Replacement front roller assembly for refrigerators. Includes leveling screw. Needed when roller is cracked, broken, or leveling screw is bent or damaged.

Flat cooktop surface that mounts over your range's burner elements. Replace if cracked, chipped, deeply scratched, or worn from years of cooking.

Replaces the front glass panel on your range oven door. Install this outer door glass when the original is cracked, chipped, broken, or shattered.

Replacement adhesive label for electric and gas ranges. Restores faded, torn, or missing model, rating, and safety information on your appliance.

This is a rubber gasket that seals the area around the dishwasher control panel or door edge, preventing moisture from escaping during wash cycles. It helps protect internal electronic components from water damage and maintains proper door sealing. Replace this gasket if you notice water leaking from the top or sides of the dishwasher door, or if the seal appears cracked, warped, or deteriorated.

This is a small air baffle breather valve that helps equalize air pressure between the interior compartment and the outside environment. It allows air to pass through while helping maintain proper temperature regulation. Replace this valve if you notice excessive frost buildup, difficulty opening the door shortly after closing it, or unusual air pressure issues inside the unit.

Foam insulation panel for range cabinets. Reduces heat transfer and stabilizes internal temperatures. Replace if torn, missing, or damaged to restore efficiency.

Replacement hinge that supports and pivots your range oven door for proper alignment. Needed when hinge is cracked, bent, or worn causing door misalignment.

This is a small bearing that fits onto the door hinge pin of a dishwasher. It allows the door to pivot smoothly when opening and closing, reducing friction and wear on the hinge assembly. Replace this bearing if the dishwasher door feels stiff, squeaks during operation, or does not stay open at the desired angle.

Replacement door trim kit with corner breaker for freezers. Installs around door edges to provide finished appearance. Needed when original trim is cracked, broken, or missing.

This is a metal broiler pan designed to sit beneath the broil element in the oven or broiler compartment. It catches grease and drippings during broiling to reduce smoke and prevent grease fires. Replace this pan if it is warped, corroded, or has holes that allow grease to leak through.

Molded insulation liner that fits inside the range oven cavity. Replace if yours is damaged, compressed, or missing to restore proper heat containment.