Need Help?
Call
Fixes ice buildup on freezer back wall and restores airflow. This radiant defrost heater melts frost from evaporator coils during defrost cycles.
After watching numerous videos I was able to discern that the problem was with one of the following: the timer, the heater, or the thermostat. a short time check showed me that the timer was working so that narrowed it down to the other two. Not having the necessary tools to check those two I ordered both parts. Once the parts came and I took out the old parts it was quite evident that it was the heater since it had black burn marks on it. I decided to install the thermostat also since it... Read more
Fix a dishwasher that stops mid-cycle with a blinking start light. This door interlock switch restores reliable operation. 20-minute DIY repair.
Looked online, appeared to be door switch or control panel. Tried door switch first, a $30 part. Installed new door switch and washer started right up and appears to be fixed. Have not tried full wash cycle yet, but problem appears to be fixed. I decided to buy part from AppliancePartsPros.com because I could return the part if it did not correct the problem, no one else offered such a deal. I will only deal with AppliancePartsPros in the future, they were extremely helpful on the phone! Read more
Supports and pivots your range door for smooth opening and closing. Replace if hinge is cracked, broken, or worn to restore proper door alignment and secure latching.
Dishwasher not spraying or making loud buzzing noise? Replace the pump and motor assembly. Moderate DIY repair takes 2-3 hours with basic tools.
Checked the grinder/pump well at the bottom of the dishwasher and fished out some aluminum foil, wire twist ties, broken plastic forks, etc. That was fun but it didn't solve the problem. Purchased new pump & motor assembly and installed it as per Youtube video. It requires pulling out the dishwasher, disconnecting electric, hotwater, and drain lines, and then removing a bunch of clips and connectors. That was time consuming but basically easy ... except that seating the new assembly gasket... Read more
Fix loud rattling or thumping noises in your dryer with a new blower wheel. Common repair when the fan hub breaks or spins freely on the motor shaft.
Blower wheel and clamp replacement. Initially, we replaced both the belt and drum roller wheels but that did not stop the noise. By reviewing videos on YouTube and AppliancePartsPros, we suspected that the blower wheel could be problematic, even though with front panel of dryer off, we did not see any visual clues to support that theory. Purchased the replacement clamp as well, just for good measure (and it was inexpensive). Note: we did call AppliancePartsPros with our model AND serial numbers... Read more
This factory-spec screw secures panels and components in your appliance. Replacing a missing or stripped fastener restores a tight, rattle-free fit so parts stay aligned and operate as designed.
Replaced Wheel-Tub. Read more
Replace a broken or fatigued oven door spring to restore proper counterbalance. Installs behind side panel. Ensures door closes firmly and seals correctly.
It was a simple fix. I removed the six screws holding the side panel on the range. Removed the broken parks of the spring. I use a screwdriver to help stretch the new spring into place. I then replaced the side panel and screwed it on. About ten minutes work. Read more
Soap or rinse aid dispenser not opening? This wax motor actuates the dispenser door release. DIYers report 15-30 minute repairs with basic tools.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
Oven won't turn off or stays on low heat? This temperature-sensing thermostat regulates oven heat and prevents overheating. Moderate DIY repair.
I replaced the thermostat and its control switch as it was not able to turn off. Read more
This flume hose kit replaces the flexible hose that routes water from the dispenser/fill flume into the washer tub. Restoring a tight, unobstructed hose helps prevent leaks and ensures detergents, bleach, and softener are carried into the wash.
I figured it had to be the flume; changed the flume and hose, mounting screws Read more
Ice won't dispense or auger motor torn from housing? This ice dispenser enclosure supports the auger and motor. Moderate DIY repair fixes broken mounts.
Removed the broken ice enclosure tray, disconnecting and removing the motor and cube/crushed ice selector mechanism. Mounted the motor and selector mechanism to the rear of the new ice tray enclosure and installed the enclosure to the freezer compartment walls. Read more
This 240-volt heater assembly restores the appliance's ability to generate and maintain heat during operation, helping cycles reach designed temperatures for proper performance and results. What it does:
Replaced the heating element following a video online, went great and fixed the problem. Read more
Color: White. This basket measures about 9 inches wide by 7 inches high by 6 inches deep. The cover and handle are not included. The cover is no longer available. For the handle order W11033847.
Bought a new one that you had available. Best reliable source I have found to date. Read more
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Replaced It With New One Read more
Replaces the upper butt hinge assembly that mounts to the cabinet and supports your freezer or refrigerator door. Needed when hinge is cracked or worn.
Looked up parts on internet using diagrams, ordered parts, they arrived in 2 days and installed them. Read more
Adjustable front leveling leg threads into the base corner of your range to raise or lower the unit. Replace if broken, cracked, or missing to level your range.
Could not level stove. Front leveling legs had pieces broken out where leg contacted floor. Back leveling legs were worn and did not stay at corrected height when stove returned to full weight on floor. Replaced both front and back leveling legs, and stove was able to be leveled. Also bought Touchup Paint for numerous nicks and scratches - color matched perfectly. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.