Maytag Refrigerator Bracket & Flange

Support base bracket for side-by-side refrigerators. Mounts on the front left side to provide structural support. Replace if cracked or broken.

Secures the water tank assembly to your refrigerator cabinet. Replace this bracket if it's cracked, broken, or missing to keep the tank stable.

Mounting bracket for bottom-mount refrigerators. Secures internal components in place. Replace if bracket is cracked, broken, or missing hardware.

Rear support base bracket for refrigerators. Secures base components at the back of the unit. Replace if cracked, broken, or missing for stability.

Secures the icemaker assembly inside your refrigerator freezer compartment. Replace this bracket if it's cracked, broken, or missing to restore support.

Secures and supports internal components in your refrigerator. Replace if bent, broken, or missing to restore proper alignment and stability.

Mounting bracket that secures the solenoid valve in your refrigerator. Replace this bracket if it's cracked, broken, or missing to properly support the valve.

Secures and aligns refrigerator components for proper fit. Replace if your mounting bracket is cracked, broken, or missing to restore stability.

This timer mounting bracket secures the appliance timer assembly to the cabinet so the timer stays aligned and stable during operation. Replaces a worn or broken bracket to restore proper timer support and reduce vibration. What it does:

• Holds the timer/timer motor firmly in place on the control panel or chassis
• Prevents the timer from shifting or rattling during cycles
• Helps maintain proper gear alignment for accurate cycle timing
• Commonly replaced when bracket is bent, cracked, or missing mounting studs

• One timer mounting bracket

• Basic hand tools required; disconnect power before beginning repair
• Inspect related fasteners and the timer housing for additional damage
• Handle the timer assembly carefully to avoid damaging wiring or connectors

This pivot arm is a direct-replacement lever that restores stable pivoting for the appliance door/assembly, helping the door open and close smoothly and reducing play or binding. It's a simple, durable part for reliable motion. What it does:

• Supports the door or related assembly and provides the pivot point for opening and closing
• Restores proper alignment and reduces excessive wobble or looseness at the hinge
• Eliminates binding, rubbing, or uneven movement that can cause noise or wear
• Works with the existing hinge hardware and mounting points to return smooth operation

• One pivot arm

• Disconnect power (and water if applicable) before beginning any repair
• Access may require opening the cabinet or removing the outer panel—use basic hand tools
• Reinstall using the original fasteners; ensure the arm is seated and moves freely after assembly

Left hand side

Mounting bracket that secures the inverter box inside your refrigerator. Replace if cracked, bent, or missing to properly support the inverter assembly.