Need Help?
Call
Ice won't dispense or motor hums without dispensing? A faulty ice container bin often causes these issues. Simple replacement restores ice dispensing.
I ordered a complete new bin with everything in it attached already. All I had to do was wash it and set it in the compartment on freezer door. Within a couple hours, I had ice again. Easy fix. Read more
Usually ships within 4 - 14 days
This ice enclosure is the molded housing that surrounds the icemaker inside the freezer, helping position the assembly and guide airflow for reliable ice production. Replace a cracked or missing cover to restore proper fit and protection around the icemaker.
Ordered new enclosure. Place ice maker into 'off' position. Remove ice tray assembly by pulling forward. Unscrew left hand side screw under old enclosure. Pulled broken part forward and up slightly. Unhooked wire harness from back of freezer. You can reach from underneath pulled out part. Or from top if you tilt rear of part down. Pull assembly out. Remove solenoid and motor. 4 screws each. Motor just needed plastic scarps removed. Remove auger drive fork (left hand thread = turn to... Read more
Ice maker not working or frosting over? This protective cover shields the control module from debris and moisture. Easy 30-minute DIY installation.
Ordered new ice maker and some additional parts. They were on my porch the next morning. It took about 30 minutes to install and had ice by mid afternoon. Read more
Ice maker won't stop making ice or overflows? This shut-off arm controls ice production by signaling when the bin is full. Direct replacement part.
Ice maker not dispensing cubes properly? This stripper arm guides ice through the maker. Common fix when tabs break. Takes about 15 minutes to install.
New slide Read more
Ice not dispensing or partially ejecting? This refrigerator ice maker ejector arm pushes ice cubes from the mold into the bin. Quick DIY fix.
Ice maker won't stop making ice or overflows? This shut-off arm controls ice production in your refrigerator. Direct replacement part for common issues.
Ice maker producing misshapen cubes or not freezing properly? This ice mold tray forms and shapes individual cubes in your refrigerator's ice maker assembly.
Ice maker not ejecting cubes or jammed? This ejector arm controls ice cube release from the mold. Common fix for ice production issues in minutes.
This ejector arm sweeps across the ice maker mold to push finished ice cubes out and into the storage bin. It is a dual-arm design for an 8-cube ice maker tray. Replace this part if ice cubes are not being released from the mold, the arm is bent or broken, or the ice maker is cycling but not dispensing ice into the bin.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.