Maytag Tube Or Fitting

Upper broiler burner tube for gas ranges. Delivers gas from the manifold to the broiler burner. Replace if cracked, damaged, or corroded to restore proper fit.

Gas tube for cooktop burner assembly. Connects gas supply to burner manifold. Replace if tube is cracked, kinked, corroded, or leaking gas.

Gas tubing that connects the gas supply to burners in your cooktop. Replace if cracked, kinked, worn, or damaged to restore safe gas flow.

This gas tubing is the rigid metal line that routes gas between the range's supply and internal gas valve or burners, restoring safe fuel flow when the original tube is damaged or leaking. Designed as a direct replacement to match factory fit and routing. What it does:

• Carries natural gas or LP from the inlet to the appliance's internal gas valve/burner assembly
• Replaces cracked, corroded, bent or leaking tubing that can cause gas odors or improper burner operation
• Restores correct gas routing so burners ignite and operate reliably
• Helps stop visible leaks when the original tube is compromised

• One gas tubing

• Turn off the gas supply and electrical power to the appliance before starting work
• Installation may require removing panels and loosening fittings; use proper flare-wrench or line tools to avoid damaging fittings
• After install, test all connections for leaks with a soap solution or approved gas leak detector—do not use an open flame

This gas tubing is a replacement tubing connector used to route gas between components in a gas appliance. It restores a secure gas path so burners and valves can receive fuel safely. What it does:

• Replaces damaged or corroded tubing that can restrict or interrupt gas flow
• Restores a proper gas connection to burners, valves, or regulators
• Helps stop symptoms like reduced burner operation, intermittent ignition, or visible rusted/dented tubing
• Provides a secure metal line used with proper fittings and seals

• Turn off gas supply and unplug the appliance before starting any service
• Inspect fittings and use correct gaskets/flare fittings; tighten to OEM torque specifications
• Check all connections for leaks with a gas leak detector or soapy water after installation