Murray Parts

This is a replacement wheel designed for use on walk-behind lawn mowers. It attaches to the mower deck axle and allows the mower to roll smoothly across the lawn. Replace this wheel if it is cracked, wobbles on the axle, has worn-down treads that cause poor traction, or if the hub is damaged and no longer holds securely.

This flat washer is used to attach the idler pulley in a number of small and medium sized gasoline powered engines. These engines include snow blowers, log splitters, riding mowers, lawn tractors, and chippers. Because the idler pulley is subject to a great deal of resistance when the pulley is engaged, eventually the pulley will wear out. Should there be a squealing sound when engaging the drive, the problem is likely the idler pulley. In these cases, the pulley must be replaced. It is a good idea to replace the surrounding hardware when replacing the idler pulley; tNhis includes the flat washer, which is subject to corrosion during heavy use. To replace the idler pulley, first detach the spark plug cap. If on a mower or tractor, drop the mower deck. Remove the original pulley and install in order: replacement pulley, hex bolt, flat washer, flange nut. Apart from dropping the mower deck, the only tools required to complete this installation may be a 9/16 ratchet and combination wrench. This washer is a genuine OEM replacement part, designed to perfectly replicate the original piece. This washer is compatible with Troy-Bilt, Yard Man, Yard Machines, MTD, and Craftsman devices.

Fastening screw for lawn mowers and tractors. Secures components throughout the equipment. Replace if stripped, broken, or missing during repairs.

Belt keeper rod bracket for lawn tractors. Mounts near the deck to guide and retain drive belts. Replace if bent, broken, or missing to prevent belt slippage.

Throttle housing and trigger assembly for gas line trimmers. Includes plastic housing, trigger, and spring. Replace if cracked, broken, or worn out.

Flywheel assembly for tillers and outdoor power equipment. Replaces cracked, damaged, or worn flywheels that affect engine timing and cooling fan operation.

Plastic flex tube for gas leaf blowers. Connects engine components for airflow. Replace if cracked, split, or worn from extended use.

This is a ratchet pawl assembly used in the recoil starter mechanism of a string trimmer. It engages the starter pulley to turn the engine over when the pull cord is yanked. Replace this part if the pull cord pulls freely without engaging the engine or if the trimmer fails to start due to a slipping or broken starter pawl.

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Throttle cable for gas line trimmers. Connects carburetor to throttle trigger. Replace if damaged, kinked, frayed, or broken during use.

This flywheel assembly mounts on the engine crankshaft of a gas-powered line trimmer and provides the rotational mass needed to keep the engine running smoothly between power strokes. It also drives the ignition system by passing magnets over the ignition coil to generate spark. Replace this flywheel if the engine has no spark, runs erratically, or if the flywheel is cracked, has damaged magnets, or a sheared keyway.

Ignition coil module assembly for gas string trimmers. Mounts to engine block and connects to spark plug. Replace if cracked, damaged, or contacts are worn.