Murray String Trimmer Parts

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

This flywheel assembly mounts on the engine crankshaft of a gas-powered line trimmer and provides the rotational mass needed to keep the engine running smoothly between power strokes. It also drives the ignition system by passing magnets over the ignition coil to generate spark. Replace this flywheel if the engine has no spark, runs erratically, or if the flywheel is cracked, has damaged magnets, or a sheared keyway.

Ignition coil module assembly for gas string trimmers. Mounts to engine block and connects to spark plug. Replace if cracked, damaged, or contacts are worn.

Ignition module for gas leaf blowers and line trimmers. Mounts to the engine to control spark timing. Replace if cracked, damaged, or missing.

Upper boom assembly for gas line trimmers. Connects the engine housing to the cutting head. Replace if cracked, bent, or structurally damaged.

Replacement throttle trigger spring for gas line trimmers. Installs inside the throttle trigger assembly. Needed when original spring is broken or missing.

Reel spool assembly for gas line trimmers. Holds and feeds trimmer line during operation. Replace if spool is cracked, worn, or missing components.

Air cleaner cover assembly for gas leaf blowers and trimmers. Protects the air filter from debris. Replace if cracked, broken, or missing clips.

Boom assembly with flexible shaft for gas line trimmers. Connects the engine to the cutting head. Replace if cracked, bent, or worn from impact damage.

This is a replacement string trimmer head that is used for a range of makes and models of trimmer. The head, sometimes called a cap, is placed on the bottom of the cutting head assembly. The glide cap is simple, but it serves an important function. It helps to keep the head from contacting the ground, so it is not damaged. The string trimmer head often comes into contact with the ground, roots, concrete, and other materials. Therefore, it can become damaged. It might crack or it could simply start to suffer from normal wear and tear after a lot of use. When this happens, owners should always replace the part sooner rather than later. If it is broken or not functioning properly, it could cause problems with the other elements in the trimmer. The replacement is simple and should not take users more than a few minutes to complete. The replacement string trimmer head is a genuine OEM part and it is sold individually. This part is for use only with string trimmers and is compatible with certain models from MTD and Cub Cadet.

Carriage screw that secures various components on lawn mowers and snowblowers. Replace if your screw is stripped, loose, missing, or damaged during use.

Replacement fuel cap assembly for tillers and outdoor power equipment. Seals fuel tank, prevents debris entry, and features vent slots. Needed when original cap is cracked, broken, or gasket is worn.

Protects the air filter on string trimmers from debris and weather exposure. Replace if cracked, broken, or missing to keep filter functioning properly.