Bosch Dishwasher SHU4002MX Parts
Genuine Bosch part
By: Bosch
Part Number: 00165256
Dishwasher won't fill or keeps overfilling? The float switch detects water levels for proper filling and draining. Accessible repair in under 30 minutes.
This part fixes the following symptoms
-
overflowing
-
Will not fill with water
See more...
Do-It-Yourself Stories from Customers like You
Inlet valve would not open to let water into the dishwasher Kurt J. • Burnsville , MN • January 09, 2015
I checked continuity at the float switch since I knew the inlet valve was working when direct wired to 120v. Switch did not have continuity. Replaced switch and inlet valve worked at start of cycle.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00263099
Replaces cracked or brittle dishwasher hose connecting the sump to the water inlet valve. Includes 2 o-rings. Essential for preventing leaks during pump replacement or routine maintenance.
Do-It-Yourself Stories from Customers like You
Low water pressure / arms not spinning Wilbur C. • Washington , DC • October 13, 2014
Used vids on youtube for steps on how to disassemble and install the pump; search "Bosch dishwasher circulation pump replacement". Also on AppliancePartsPro forums, a poster put up the Bosch "Dishwasher Service Training Manual" in .pdf. Search "Bosch dishwasher low pressure" on the forum. It's one of the post with the longest thread.
Six pointers.
1. In another forum post, the poster noted that some hoses were brittle with age - and cracked when reinstalling. I had same issue (my washer is...
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00170664
Replacement mounting bracket set for securing your dishwasher to cabinetry. Needed when original brackets are bent, broken, or missing during installation.
Do-It-Yourself Stories from Customers like You
Recently had granet countertops installed dishwasher was slidimng around needed to install side mounts to corral the dish washer Reed H. • Beaver Falls , PA • January 03, 2016
Easily installed the side mounts and put new trim around the opening.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00618605
The Roller and Cable Assembly is an OEM part for Bosch dishwashers. This assembly includes the roller and cable, which work together to facilitate the smooth operation of the dishwasher door, allowing it to open and close effortlessly.
Over time, the roller and cable can wear out or become damaged due to regular use, friction, or accidental mishandling. If either component fails, it can affect the balance and movement of the dishwasher door, making it difficult to operate.
Symptoms of a bad roller and cable assembly include:
- Difficulty in opening or closing the dishwasher door
- A sagging or misaligned door
- Unusual noises when operating the door
- The door not staying securely in place
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Door too heavy and mounting bracket broken. Jim H. • Minneapolis , MN • September 04, 2017
This turned out to be a major effort, requiring me to disconnect the dishwasher, pull it from the cabinetry and partially disassemble the dishwasher to replace the door closer pulley
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00093046
Replace your broken, cracked, or missing dishwasher silverware basket. Holds utensils securely in the lower rack during wash cycles. Includes handle.
Do-It-Yourself Stories from Customers like You
Soap dispenser did not stay closed Petra G. • West Chester , PA • October 18, 2014
After having seen the video I installed the new lid and it worked.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00165254
Replacement end cap stops for dishwasher upper rack rails. Clips onto rail ends to keep rack on track. Order when original caps are cracked or missing.
Do-It-Yourself Stories from Customers like You
Small calcium deposits on dishes and clogging up spray arms Stan K. • Gainesville , FL • August 26, 2017
Replaced these parts. Easy job. and great help online even on a Sunday.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00263102
Seals the dishwasher sump to prevent water leaks during wash cycles. Replace if you notice leaking at the base or constant drain pump operation.
Do-It-Yourself Stories from Customers like You
Bosch shv4304 water leaking into base and drain pump running constantly Jonathan F. • Highland , NY • February 05, 2018
I replaced the gaskets with products from this site which I would not have been able to do without the video on this site. Hard job. The leak was still there though, so I have some hints with this kind of washer. 1) There is a float switch on the base that turns on the drain pump when there is a leak, that is why the drain pump runs constantly, it prevents catastrophic flooding in many cases. The float consists of a little styrofoam donut that lifts an arm, all white. The arm is connected to a...
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00176121
Mounting screw that secures the toe kick panel to the bottom frame of your dishwasher. Replace if screw is lost, stripped, or damaged during installation.
Do-It-Yourself Stories from Customers like You
Bosch part(kick plate) was missing Kyle K. • Green Bay , WI • November 14, 2015
My order arrived very fast and was easy to install.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00166637
Seals the detergent dispenser to prevent leaks and ensure proper release during wash cycles. Replace if detergent leaks or dispenser malfunctions.
Do-It-Yourself Stories from Customers like You
Soap dispenser not opening Matt L. • Morrisville , VT • January 19, 2018
Replaced dispenser.
It was hard to snap into place. You don't need to order separate gasket it comes with it.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00166625
The Sealing is an OEM replacement part for Bosch brand dishwashers. Located on the perimeter of the small rinse aid compartment door, this resilient rubber piece forms an essential water-tight seal when the dispenser is closed.
Symptoms of a potentially problematic rinse aid door sealing include:
- Leakage or spills within the rinse aid reservoir
- Mineral deposits or residue build up inside the compartment
- Cracks, tears, or deformation of the sealing material
Causes of a faulty rinse aid door sealing can be repetitive opening/closing stress breaking down pliability long-term. Exposure to chemical vapors from the rinse aid may also degrade sealing properties.
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Rinse aid was drooling out of the dispenser (bosch dishwasher) Christopher B. • Chesterfield , MO • August 26, 2026
Jumped onto AppliancePartsPros.com and found the seal I needed, ordered one, and it arrived almost as fast as if using the transporter on the '67 USS Enterprise. Easy site navigation, great pricing, very speedy delivery.
Result: Rinse-aid is fully contained until the machine dispenses it.
5/5 stars for AppliancePartsPro.com. Thank you.
"Ah'll be bahck" as Arnold said.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00165263
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Do-It-Yourself Stories from Customers like You
No spray during wash cycle pump impeller was broken. Robert K. • Cazenovia , NY • February 22, 2019
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00088403
2 clamps included.
Do-It-Yourself Stories from Customers like You
Missing part to reinstall dishwasher to disposal James I. • Rochester , NY • October 07, 2014
ORDERED TUBE AND CLAMPS
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00350321
Replacement water feed tube that delivers water to the upper spray arm in your dishwasher. Replace if cracked, split at seams, or leaking due to wear.
Do-It-Yourself Stories from Customers like You
Dishes were not getting clean Dorman P. • Ponte Vedra Beach , FL • October 18, 2014
After we saw that progressively our dishes were not getting clean we investigated the condition of the spray arms and this upper feed tube assembly. We found a huge crack on the side of this piece and new not enough water was getting to the arms. We also noticed a build up of soap and lime. So we ran a cycle of vinegar and sprayed the filters and arms with lime-off-sprayed them out with a air hose "completely". Many of the small pieces of lime will clog the holes in the spray arms. Attached the...
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00263833
Fix a dishwasher that won't fill, overfills, or leaks from the base. Water inlet valve controls flow into the tub. Moderate DIY repair, 30-45 minutes.
Do-It-Yourself Stories from Customers like You
Horrible smell when running a cycle Aaron H. • Los Angeles , CA • January 13, 2017
Bacteria buildup in the venting assembly and drain hose. Replaced them and it's back to normal
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00167241
Secures the dishwasher sump or sump cover to the tub for a tight, leak-resistant seal. Replace if missing, stripped, or damaged to restore stability.
More
Genuine Bosch part
By: Bosch
Part Number: 00298550
This upper trim strip finishes the top edge of the appliance's front opening, restoring a clean look and helping protect nearby components. Replace a cracked, missing, or loose strip to keep panels aligned and secure.
- Provides a finished edge along the upper portion of the door/face area
- Helps protect adjacent components from dust and minor splashes
- Maintains proper panel gaps and alignment
- Typical symptoms: visible cracks, warping, looseness, rattling, or exposed/sharp edges
What's included: 1 upper trim strip Install notes:
- Disconnect power before servicing; also shut off water
- Remove the existing strip by releasing screws/clips; retain hardware for reuse
- Align the new strip and secure evenly—do not overtighten fasteners
- Check door/panel operation afterward to confirm proper fit and clearance
Do-It-Yourself Stories from Customers like You
Old pieces worn out Michal W. • Sterling , VA • July 18, 2015
My micro filter was in pieces when I pulled it out.
Read more
More