Kenmore Refrigerator 363.58062896 (36358062896, 363 58062896) Parts
Genuine Ge part
By: Ge
Part Number: WR30X30972
Ice maker not producing ice or won't dispense cubes? This complete ice maker assembly replaces failed units. DIY-friendly install in under 10 minutes.
Do-It-Yourself Stories from Customers like You
Ice maker would not exspell the ice after it was made. Leesinger K. • Jackson , WI • April 03, 2014
I found that the Ice Maker in my GE side by side made ice but would not kick out the ice when it had formed, the heating element or the switch that controls it didn't work. I ordered a new ice maker switched it out took less than 3 minutes. The cord was very stiff and just long enough but I got it to connect and in 35-40 minutes I had fresh ICE!!
Read more
More
$200.72
- Compare At:
-
$238.86
- You Save:
-
$38.14
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Genuine Ge part
By: Ge
Part Number: WR17X4310
Ice not dispensing or slow ice flow? This ice bucket and auger assembly stores and moves ice to your dispenser. Simple DIY install in 10-30 minutes.
Do-It-Yourself Stories from Customers like You
Refrigerator automatic ice bucket had rust on the auger helix dispenser Eric B. • Burke , VA • October 15, 2014
I ordered a new bucket and auger combination--I didn't want to have to completely disassemble the mechanism to replace the rusted auger helix dispenser, so for about twice the cost of the auger alone I got the complete assembly. The product arrived in pristine condition less than 48 hours after I purchased it online. About 10 minutes later (most of that spent taking out the old bucket and finding my philips head screwdriver), I had removed the four screws holding the cover plate on the old...
Read more
More
$308.73
- Compare At:
-
$370.48
- You Save:
-
$61.75
Genuine Ge part
By: Ge
Part Number: WR02X10322
This evaporator fan motor dust cap is an authentic OEM replacement part found on refrigerator and freezer fan motors. This dust cap prevents the fan motor bearing and housing from being damaged by dirt and debris. If the dust cap is cracked or broken, the fan may make loud squealing noises. If the dust cap is not removed and replaced, the fan could stop working and ultimately cause the refrigerator's temperature to be affected. To start, disconnect the power and water to the refrigerator. Remove food from the freezer so that the back panel of the freezer can be accessed to reach the fan. Remove the ice maker and set it outside the freezer. Disconnect the fan and take it out of the freezer to expose the fan's shaft and the dust cover. Pry the dust cover off and install the new one. Replace the fan and cover. Reconnect the wires and reinstall the icemaker. Put the food back in the freezer. Reconnect the power and water.The evaporator fan motor dust cap is a white plastic part that is sold individually. This dust cover is made for use in refrigerators manufactured by General Electric, Hotpoint, and Kenmore.
Do-It-Yourself Stories from Customers like You
Evaporator fan started making loud noise from blade hitting shroud Kerry M. • Englewood , CO • October 03, 2016
Replacement of the evaporator fan motor, fan blade, and grommets.
The amount of disassembly to reach the part took most of the effort
Read more
More
$17.48
- Compare At:
-
$20.98
- You Save:
-
$3.50
Genuine Ge part
By: Ge
Part Number: WR02X10140
Replaces worn or broken hinge cam riser on the lower door hinge. Restores smooth door lift and closing action. Essential when door sags or grinds.
Do-It-Yourself Stories from Customers like You
Hinge cam risers were worn out one was completely missing Norman C. • Spencer , IN • June 20, 2014
I made a lucky guess when I ordered the part as I had no model # or anything to go by. I just ordered what looked like the right thing and it was the exact part for my fridge. Replacement was easy.
Read more
More
$9.53
- Compare At:
-
$11.34
- You Save:
-
$1.81
Genuine Ge part
By: Ge
Part Number: WR62X26536
This armature kit is the moving plunger and linkage operated by the dispenser solenoid. It opens and closes the ice chute door during dispensing and helps it seal when idle to reduce frost and warm-air leaks.
- Converts the solenoid's electrical action into mechanical movement for the dispenser ice chute door
- Helps maintain a proper seal to limit frost and moisture around the dispenser
- Typical symptoms: ice won't dispense; chute door won't open/close; frost/ice buildup at the chute; loud buzzing or clicking from the dispenser area
- Wear or sticking of the armature/spring can hinder movement and affect dispenser operation
What's included: 1 armature kit Installation notes:
- Unplug the refrigerator and shut off water to the dispenser before servicing
- Access the dispenser mechanism in the door; remove trim/control panel per your model's service information
- Note the orientation of the armature, spring, and linkage; transfer components one-for-one to the new kit and secure hardware
- Verify the solenoid plunger moves freely, reassemble, restore power, and test dispenser operation
Do-It-Yourself Stories from Customers like You
Water was overflowing out of the ice maker during fill process and freezing into a block of ice! Steven B. • Arlington , TX • March 17, 2015
Replaced the water supply valve...boom!
Read more
More
$57.32
- Compare At:
-
$68.21
- You Save:
-
$10.89
Genuine Ge part
By: Ge
Part Number: WR2X8818
The recess door retainer secures the dispenser's ice chute flapper in the refrigerator door. Replacing a cracked or missing retainer restores proper flapper pivot and sealing to help reduce frost buildup and air leaks around the dispenser.
- Holds the recess/ice door on its pivot within the dispenser assembly
- Helps the flapper close fully to seal the ice chute
- Restores smooth open/close action of the dispenser door
- Common symptoms: loose or fallen flapper, poor chute seal, frost or condensation in the dispenser area, and ice clumping near the chute
What's included: 1 recess door retainer Install notes:
- Unplug the refrigerator before servicing the dispenser
- Carefully remove the dispenser bezel/control panel to access the ice chute door assembly
- Note spring orientation and retainer position; transfer components to the new retainer
- Verify flapper movement and seal before reassembly and restoring power
Do-It-Yourself Stories from Customers like You
Water line in door kept freezing. Charles N. • Mcdonough , GA • October 15, 2017
Replaced springs, flapper assembly and ice door retainer as described in videos and it was easy. So far so good..water dispenses.
Read more
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WR2X9561
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
Do-It-Yourself Stories from Customers like You
Ice maker would not dispense ice and chute/container would frost over Theo S. • Tallahassee , FL • October 01, 2014
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open.
I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video.
The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR62X107
Door solenoid with plunger.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$73.95
- Compare At:
-
$88.00
- You Save:
-
$14.05
Genuine Ge part
By: Ge
Part Number: WR87X20798
Refrigerator not cooling or compressor clicking on and off? This compressor kit restores cooling. Requires certified technician with specialty tools.
More
$489.52
- Compare At:
-
$577.63
- You Save:
-
$88.11
Genuine Ge part
By: Ge
Part Number: WR60X10262
This replacement motor powers the dispenser's auger/crusher mechanism to move ice from the bucket to the chute. Replacing a weak or seized motor helps restore reliable cube or crushed-ice dispensing from the freezer door.
- Drives the ice auger/crusher to feed ice from the bucket through the dispenser chute
- Helps deliver cubes or crushed ice, depending on the control selection
- Common symptoms: no ice dispensing, auger not turning, loud humming or grinding, intermittent or weak dispensing
- Located in the freezer-door dispenser assembly and engages the ice bucket coupler
What's included: One dispenser crusher motor. Install notes:
- Disconnect power to the refrigerator before servicing
- Remove the ice bucket and dispenser trim/panel to access the motor; note wire orientation and fasteners
- Transfer any mounting hardware or coupler from the old motor
- Reassemble, restore power, and test ice dispensing
Do-It-Yourself Stories from Customers like You
Needed new ice maker motor and circuit board Edward Z. • Berlin , CT • August 19, 2016
I watched the help videos first, then ordered the parts, and installed all items as in the video.
Read more
More
$151.67
- Compare At:
-
$178.97
- You Save:
-
$27.30
Genuine Ge part
By: Ge
Part Number: WR23X10300
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Do-It-Yourself Stories from Customers like You
Power cord needed to be replaced Jorge V. • Tucson , AZ • November 14, 2015
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge.
Read more
More
Genuine Ge part
By: Ge
Part Number: WH2X930
Black. 8-18 AB HXW 3/8
Do-It-Yourself Stories from Customers like You
Oven door trim rusted Gladys R. • Weston , FL • August 08, 2016
I ordered the part and was impressed to receive it within two day! I didn't need the screws I ordered (which I ordered just in case) but the trim was put on with no problem and my oven looks brand new again! Thank you!
Read more
More
$11.74
- Compare At:
-
$13.85
- You Save:
-
$2.11
Genuine Ge part
By: Ge
Part Number: WR02X22869
This is a grommet and it is intended for use on refrigerators and freezers. This is a genuine replacement part made by General Electric. A new grommet might be needed if the current one is visibly worn out or damaged in any way. If there are noises from vibration coming from the lower back area of the fridge there might be need for a new grommet. This is an OEM part sourced directly from the manufacturer, and it is sold individually. It is compatible with refrigerators and freezers, or units with a compressor and is made by General Electric.
Do-It-Yourself Stories from Customers like You
Leaking vaporizer pan Rich M. • La Verne , CA • May 04, 2019
Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor
Read more
More
Genuine Ge part
By: Ge
Part Number: WR60X10008
Freezer not cooling evenly or food freezing? A failed evaporator fan motor stops cold air circulation. This repair restores proper airflow and temps.
Do-It-Yourself Stories from Customers like You
Evaporator Motor stopped working and the Refrigerator was Freezing food the bottom shelves Al K. • Wethersfield , CT • March 28, 2014
Replaced the Evaporator Motor
Read more
More
$174.95
- Compare At:
-
$201.05
- You Save:
-
$26.10
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Water tank leak in refrigerator when using the water dispenser. Stephen B. • Summerville , SC • February 24, 2019
Replaced the water tank. Followed the video instruction provided by Appliance Parts Pros.
Very good instruction.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51