Kenmore Refrigerator 363.58077891 (36358077891, 363 58077891) Parts
Genuine Ge part
By: Ge
Part Number: WR60X114
Freezer not cooling or making buzzing noise? The evaporator fan blade circulates cold air. Easy DIY fix in under 5 minutes—simply pull off and press on.
Do-It-Yourself Stories from Customers like You
Broken fan blade Thomas H. • West Blocton , AL • April 21, 2014
I used a set of ring pliers to remove the old retaining ring, then spread the plastic ribs around the fan motor shaft with a small flat bladed screwdriver to ease removal of the old fan blade. I reversed the process to replace the blade, gently tapping a socket from my socket wrench set placed over the motor shaft and ribs with a small rubber mallet. I stopped when the shaft protruded about 1/8" beyond the plastic ribs of the new fan blade, then installed the new retaining clamp ring with the...
Read more
More
$22.95
- Compare At:
-
$27.31
- You Save:
-
$4.36
Genuine Ge part
By: Ge
Part Number: WR1X2027
Replacement door closure spring for refrigerator hinges. Installs on door hinge assembly to provide tension for proper closing. Needed when broken or worn.
Do-It-Yourself Stories from Customers like You
Freezer door would not close well Juan D. • Rio Grande , FL • September 19, 2014
I replaced the lever asm. and spring
Read more
More
$37.41
- Compare At:
-
$44.52
- You Save:
-
$7.11
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$32.95
- Compare At:
-
$38.88
- You Save:
-
$5.93
Genuine Ge part
By: Ge
Part Number: WR51X443
Ice buildup in freezer? This defrost heater and thermostat assembly melts frost from evaporator coils. Moderate DIY repair restores proper cooling.
Do-It-Yourself Stories from Customers like You
Defrost heater not working Jayesh P. • La Canada , CA • June 12, 2014
I replaced defrost heater with thermostat. It is a very easy and there is YouTube tutorial video for that.
Read more
More
$117.34
- Compare At:
-
$145.61
- You Save:
-
$28.27
Genuine Ge part
By: Ge
Part Number: WR62X26536
This armature kit is the moving plunger and linkage operated by the dispenser solenoid. It opens and closes the ice chute door during dispensing and helps it seal when idle to reduce frost and warm-air leaks.
- Converts the solenoid's electrical a
Do-It-Yourself Stories from Customers like You
Water was overflowing out of the ice maker during fill process and freezing into a block of ice! Steven B. • Arlington , TX • March 17, 2015
Replaced the water supply valve...boom!
Read more
More
$54.95
- Compare At:
-
$65.94
- You Save:
-
$10.99
Genuine Ge part
By: Ge
Part Number: WR2X8818
The recess door retainer secures the dispenser's ice chute flapper in the refrigerator door. Replacing a cracked or missing retainer restores proper flapper pivot and sealing to help reduce frost buildup and air leaks around the dispenser.
- Holds
Do-It-Yourself Stories from Customers like You
Yes ice was not coming out of the dispenser Jason S. • Goose Creek , SC • December 02, 2014
I replaced the solenoid, door, spring and bucket. The bucket cracked from ice freezing inside it. Ice froze inside the bucket because the solenoid stopped pulling the door closed which allowed hot humid air into the freezer. While I was in there I replaced the dispenser door, spring and crank because they are cheap and the old ones were moldy. The mold is most likely from the door not closing and causing condensation on the parts as well.
Read more
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WR62X107
Door solenoid with plunger.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$72.38
- Compare At:
-
$86.13
- You Save:
-
$13.75
Genuine Ge part
By: Ge
Part Number: WR2X9561
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
Do-It-Yourself Stories from Customers like You
Ice maker would not dispense ice and chute/container would frost over Theo S. • Tallahassee , FL • October 01, 2014
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open.
I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video.
The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR60X10262
This replacement motor powers the dispenser's auger/crusher mechanism to move ice from the bucket to the chute. Replacing a weak or seized motor helps restore reliable cube or crushed-ice dispensing from the freezer door.
- Drives the ice auger/cr
Do-It-Yourself Stories from Customers like You
Needed new ice maker motor and circuit board Edward Z. • Berlin , CT • August 19, 2016
I watched the help videos first, then ordered the parts, and installed all items as in the video.
Read more
More
$147.95
- Compare At:
-
$176.06
- You Save:
-
$28.11
Genuine Ge part
By: Ge
Part Number: WR23X10300
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Do-It-Yourself Stories from Customers like You
Power cord needed to be replaced Jorge V. • Tucson , AZ • November 14, 2015
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR02X22869
This is a grommet and it is intended for use on refrigerators and freezers. This is a genuine replacement part made by General Electric. A new grommet might be needed if the current one is visibly worn out or damaged in any way. If there are noises fro
Do-It-Yourself Stories from Customers like You
Leaking vaporizer pan Rich M. • La Verne , CA • May 04, 2019
Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor
Read more
More
Genuine Ge part
By: Ge
Part Number: WR60X10008
Freezer not cooling evenly or food freezing? A failed evaporator fan motor stops cold air circulation. This repair restores proper airflow and temps.
Do-It-Yourself Stories from Customers like You
Evaporator Motor stopped working and the Refrigerator was Freezing food the bottom shelves Al K. • Wethersfield , CT • March 28, 2014
Replaced the Evaporator Motor
Read more
More
$158.95
- Compare At:
-
$189.15
- You Save:
-
$30.20
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Not getting crushed ice Mike S. • Glendale , AZ • March 16, 2020
New parts.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Genuine Ge part
By: Ge
Part Number: WR01X10631
Replacement mounting screw for refrigerator panels, brackets, and hardware. Restores secure fit when original is missing, stripped, or corroded.
Do-It-Yourself Stories from Customers like You
Door did not seal closed Sharon F. • West Hills , CA • September 17, 2018
Hinge missing screws. Replaced 2.
Perfect now
Read more
More
$4.61
- Compare At:
-
$8.36
- You Save:
-
$3.75
Genuine Ge part
By: Ge
Part Number: WR2X4754
Secures water and drain tubing to prevent leaks, noise, and vibration. Replace if loose, cracked, or missing. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR1X1367D
Includes 12 retainer rings.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$13.79
- Compare At:
-
$16.41
- You Save:
-
$2.62