Kenmore Refrigerator 363.9542683 (3639542683, 363 9542683) Parts
Genuine Ge part
By: Ge
Part Number: WR17X11349
Plastic water line that connects the water inlet valve to the ice maker. Replace if cracked, leaking, or damaged. Includes installation video.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$8.95
- Compare At:
-
$10.56
- You Save:
-
$1.61
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Genuine Ge part
By: Ge
Part Number: WR17X4310
Ice not dispensing or slow ice flow? This ice bucket and auger assembly stores and moves ice to your dispenser. Simple DIY install in 10-30 minutes.
Do-It-Yourself Stories from Customers like You
Refrigerator automatic ice bucket had rust on the auger helix dispenser Eric B. • Burke , VA • October 15, 2014
I ordered a new bucket and auger combination--I didn't want to have to completely disassemble the mechanism to replace the rusted auger helix dispenser, so for about twice the cost of the auger alone I got the complete assembly. The product arrived in pristine condition less than 48 hours after I purchased it online. About 10 minutes later (most of that spent taking out the old bucket and finding my philips head screwdriver), I had removed the four screws holding the cover plate on the old...
Read more
More
$308.73
- Compare At:
-
$370.48
- You Save:
-
$61.75
Genuine Ge part
By: Ge
Part Number: WR07X10055
Compressor clicks on and off or won't start? This PTC start relay energizes the compressor start winding to restore consistent cooling. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
The compressor was clicking on and off refrigerator was blowing hot air inside Steve F. • Sealy , TX • May 27, 2017
I bought this relay switch and it works great. On the left side of the compressor there is a plastic cover you pry off with a screw driver. The relay switch had one wire plug on it. Just pull the wire off and the pull the relay switch off the compressor.
Read more
More
$28.55
- Compare At:
-
$34.26
- You Save:
-
$5.71
Genuine Ge part
By: Ge
Part Number: WR62X26536
This armature kit is the moving plunger and linkage operated by the dispenser solenoid. It opens and closes the ice chute door during dispensing and helps it seal when idle to reduce frost and warm-air leaks.
- Converts the solenoid's electrical action into mechanical movement for the dispenser ice chute door
- Helps maintain a proper seal to limit frost and moisture around the dispenser
- Typical symptoms: ice won't dispense; chute door won't open/close; frost/ice buildup at the chute; loud buzzing or clicking from the dispenser area
- Wear or sticking of the armature/spring can hinder movement and affect dispenser operation
What's included: 1 armature kit Installation notes:
- Unplug the refrigerator and shut off water to the dispenser before servicing
- Access the dispenser mechanism in the door; remove trim/control panel per your model's service information
- Note the orientation of the armature, spring, and linkage; transfer components one-for-one to the new kit and secure hardware
- Verify the solenoid plunger moves freely, reassemble, restore power, and test dispenser operation
Do-It-Yourself Stories from Customers like You
Water was overflowing out of the ice maker during fill process and freezing into a block of ice! Steven B. • Arlington , TX • March 17, 2015
Replaced the water supply valve...boom!
Read more
More
$57.32
- Compare At:
-
$68.21
- You Save:
-
$10.89
Genuine Ge part
By: Ge
Part Number: WR2X8818
The recess door retainer secures the dispenser's ice chute flapper in the refrigerator door. Replacing a cracked or missing retainer restores proper flapper pivot and sealing to help reduce frost buildup and air leaks around the dispenser.
- Holds the recess/ice door on its pivot within the dispenser assembly
- Helps the flapper close fully to seal the ice chute
- Restores smooth open/close action of the dispenser door
- Common symptoms: loose or fallen flapper, poor chute seal, frost or condensation in the dispenser area, and ice clumping near the chute
What's included: 1 recess door retainer Install notes:
- Unplug the refrigerator before servicing the dispenser
- Carefully remove the dispenser bezel/control panel to access the ice chute door assembly
- Note spring orientation and retainer position; transfer components to the new retainer
- Verify flapper movement and seal before reassembly and restoring power
Do-It-Yourself Stories from Customers like You
Water line in door kept freezing. Charles N. • Mcdonough , GA • October 15, 2017
Replaced springs, flapper assembly and ice door retainer as described in videos and it was easy. So far so good..water dispenses.
Read more
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WR62X107
Door solenoid with plunger.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$73.95
- Compare At:
-
$88.00
- You Save:
-
$14.05
Genuine Ge part
By: Ge
Part Number: WR60X10262
This replacement motor powers the dispenser's auger/crusher mechanism to move ice from the bucket to the chute. Replacing a weak or seized motor helps restore reliable cube or crushed-ice dispensing from the freezer door.
- Drives the ice auger/crusher to feed ice from the bucket through the dispenser chute
- Helps deliver cubes or crushed ice, depending on the control selection
- Common symptoms: no ice dispensing, auger not turning, loud humming or grinding, intermittent or weak dispensing
- Located in the freezer-door dispenser assembly and engages the ice bucket coupler
What's included: One dispenser crusher motor. Install notes:
- Disconnect power to the refrigerator before servicing
- Remove the ice bucket and dispenser trim/panel to access the motor; note wire orientation and fasteners
- Transfer any mounting hardware or coupler from the old motor
- Reassemble, restore power, and test ice dispensing
Do-It-Yourself Stories from Customers like You
Needed new ice maker motor and circuit board Edward Z. • Berlin , CT • August 19, 2016
I watched the help videos first, then ordered the parts, and installed all items as in the video.
Read more
More
$151.67
- Compare At:
-
$178.97
- You Save:
-
$27.30
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Not getting crushed ice Mike S. • Glendale , AZ • March 16, 2020
New parts.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Genuine Ge part
By: Ge
Part Number: WR1X1367D
Includes 12 retainer rings.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$13.79
- Compare At:
-
$16.41
- You Save:
-
$2.62
Genuine Ge part
By: Ge
Part Number: WR1X5278
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
More
Genuine Ge part
By: Ge
Part Number: WR17X10273
Ice storage bin holds and stores ice produced by the refrigerator's ice maker so cubes are ready for dispensing and stay contained. Replaces cracked, broken, or missing bins to restore normal ice storage and delivery. What it does:
- Collects and stores ice made by the ice maker so cubes are available for dispensing.
- Guides ice toward the dispenser/auger area and helps prevent ice from spilling into the freezer.
- Restores proper ice containment when the original bin is cracked, warped, or missing.
- Helps reduce ice clumping and jams caused by broken or misaligned storage containers.
What's included: One ice storage bin. Install notes:
- Disconnect power to the refrigerator before removing or installing the ice bin.
- Remove shelves or drawer(s) as needed for access; lift out the old bin carefully to avoid damaging the ice maker or dispenser components.
- Align tabs and guides on the new bin and slide into place without forcing; listen for the bin to seat properly.
- After installation, restore power and run the ice maker/dispenser through a test cycle; discard the first batch of ice after reinstallation.
Do-It-Yourself Stories from Customers like You
Ice maker door kept falling off & vegetable drawer wasn't level & wouldn't slide easily Susan C. • Morenci , MI • January 20, 2020
I ordered the ice bin storage door, slid the left side on peg then snapped the right side on that peg - Presto! Problem solved! Replaced the right side slide on vegetable drawer. Watched the video, everything went exactly like video showed - very easy! Both parts took maybe 15 minutes total to replace! Very pleased! The customer service representative was very friendly and I received my order in 2 days, I really couldn't ask for better service! I highly recommend Appliance Parts Pros!
Read more
More
$42.41
- Compare At:
-
$50.47
- You Save:
-
$8.06
Genuine Ge part
By: Ge
Part Number: WZ4X241D
Includes 12 screws. Size: 8-18 ab.
Do-It-Yourself Stories from Customers like You
We didn't have a power cord for our dryer Heather B. • Dulce , NM • October 27, 2018
Ordered the cord through appliance parts pros, with additional screws and it works! Yay after waiting months and everywhere was out. Thank you.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR2X7905
Seals the ice bucket to prevent spills, frost buildup, and water pooling. Replace when ice shifts or water collects. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
The augor in the ice maker was rusty Angie K. • Greenwich , CT • November 15, 2015
Changed the part with SS part.
Read more
More
$10.07
- Compare At:
-
$11.94
- You Save:
-
$1.87
Genuine Ge part
By: Ge
Part Number: WR2X4138
Mounting spacer maintains proper clearance between refrigerator panels, doors, or components. Replace if cracked, broken, or missing to restore fit.
More
$15.41
- Compare At:
-
$18.34
- You Save:
-
$2.93
Genuine Ge part
By: Ge
Part Number: WR01X10623
Replacement 8-18 x 9/16 machine screw for securing panels, brackets, and internal components. Needed when fasteners are stripped, missing, or worn.
Do-It-Yourself Stories from Customers like You
Ice maker internal door not closing John M. • St. Augustine , FL • January 12, 2016
Originally replaced the door and spring but it still would not close. This time, replace the solenoid and it works great!!!
Read more
More
$14.95
- Compare At:
-
$17.79
- You Save:
-
$2.84