Range / Cooktop / Oven Clip Or Clamp

This cable clamp secures a wiring harness to the appliance frame to prevent chafing and strain on electrical connections. It helps keep wires routed neatly and reduces the risk of abrasion-related faults. What it does:

• Holds wiring harnesses in place to prevent rubbing against sharp edges or moving parts
• Reduces strain on terminal connections and wire leads
• Helps prevent intermittent electrical problems caused by loose or misrouted wires
• Keeps routing tidy for safer, cleaner internal layouts

• One cable clamp

• Disconnect power to the appliance before beginning any repair
• Replace with the same clamp type and orientation as the original; secure without over-tightening
• Route wires so insulation is not pinched; verify clearance from moving parts
• If you see damaged insulation or frayed wires, repair those issues before reassembly

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

This electrode clip secures the spark electrode/igniter assembly at the burner so the igniter stays in the correct position for reliable ignition. It replaces a worn or broken clip to restore stable spark alignment. What it does

• Holds the spark electrode or igniter in the proper position at the burner for consistent ignition.
• Helps prevent the electrode from shifting or touching other components, which can stop sparking.
• Commonly used when burners fail to ignite or sparking is intermittent due to a loose or damaged clip.
• Works with the appliance's ignition assembly to maintain correct gap and alignment.

• One electrode clip.

• Always disconnect power and shut off gas supply before accessing the burner or ignition assembly.
• Handle the electrode/igniter carefully—it's brittle and can crack if flexed or bumped.
• Access typically requires removing burner grates and burner caps; keep screws and small parts organized.
• If the electrode or wire shows heavy corrosion or damage, replace those components as well.