Range Insulation, Sound Dampening Parts

This insulating foam strip fits inside the refrigerator door frame to help seal the door and reduce air leaks. Replacing a worn or damaged insulator restores better temperature control and helps prevent frost buildup along the door. What it does

• Fills the gap between the door and cabinet frame to improve the seal and reduce cold air loss.
• Helps prevent frost and moisture buildup around the door frame.
• Can reduce compressor run time caused by inefficient door sealing.
• Addresses symptoms like warm spots on the door edge, visible gaps, or excess frost near the door.

• Disconnect power to the appliance before beginning any repair.
• Remove the door liner or inner panel as required to access the frame channel (follow your model's service instructions).
• Press or slide the insulator into the channel; adhesive or retainer clips may be used depending on model.

This insulator protects and cushions the appliance control module, helping prevent electrical shorts and physical damage to the board. It's a simple replacement that supports reliable control operation. What it does:

• Separates the control/module from the chassis to prevent shorting and rubbing
• Cushions the module to reduce vibration-related connector issues
• Helps keep wiring and components positioned correctly for consistent electrical contact
• Can reduce intermittent control problems caused by loose or damaged insulation

• Disconnect power before beginning any repair to avoid shock or damage
• Access the control panel or console per your appliance's service instructions
• Fit the insulator under/around the module as shown in the parts diagram; ensure correct orientation and secure mounting hardware
• Avoid touching circuit board components; if connectors were removed, reseat firmly before reassembly

This bracket insulation is a molded foam pad that cushions and insulates a mounting bracket to reduce vibration, protect nearby components, and help maintain proper thermal separation. It restores the original fit and noise-control function. What it does:

• Cushions metal bracket to reduce vibration and rattling during operation
• Provides thermal insulation to help prevent heat transfer and local frost or condensation
• Protects wiring and nearby components from abrasion and metal-to-metal contact
• Helps maintain correct spacing and alignment of the bracket assembly

• Intended to slip or press into place on the bracket; no special tools usually required
• Clean mounting surfaces of debris and old adhesive before installing for a secure fit
• Replace torn, compressed, or missing insulation to restore proper function
• Disconnect power to the appliance before working near electrical or moving parts

This insulated oven door panel cushions and stabilizes the oven door cavity, helping maintain cooking temperatures and reducing exterior heat. Replacement restores proper thermal barrier and can improve safety and energy retention. What it does:

• Provides the thermal insulation layer inside the oven door to help keep heat in the oven cavity
• Reduces outer door surface temperature for safer contact during use
• Helps the oven hold set temperatures more consistently by limiting heat loss through the door
• Supports correct alignment and spacing of inner door panels when installed

• One insul door (single oven door insulation panel) as specified by the manufacturer

• Intended for repair technicians or experienced DIYers; disconnect power before starting and ensure the appliance is cool
• Remove the oven door per the manufacturer's instructions to access the inner door cavity; handle insulation carefully to avoid tearing
• Replace only the specified insulation panel and reassemble door panels in the correct order with all fasteners snug but not over-tightened
• If any door glass, gaskets, or mounting hardware are damaged or missing, replace them as well to ensure safe operation