Refrigerator Adaptor Or Connector

This rubber grommet seals and cushions the dishwasher water tube where it passes through the tub or panel, helping prevent leaks and reduce tube movement. It's a small but important part for reliable water routing. What it does:

• Creates a watertight seal around the water tube to help prevent leaks and water damage.
• Cushions and secures the tube to reduce vibration, rubbing, and wear.
• Helps keep the water tube properly routed and positioned during operation.
• Commonly replaced when you see leaking near the tub, water pooling under the unit, or a loose/misaligned tube.

• One rubber water-tube grommet

• Disconnect power and shut off water supply before servicing the appliance.
• Access the area per your model's service instructions (lower kickplate or cavity panel removal may be required).
• Remove the old grommet and press the replacement into the tub or panel opening; then re-seat the water tube through the grommet until it fits snugly.
• After reassembly, restore power and water and run a short cycle to check for proper routing and leaks.

This connector door harness links the cabinet wiring to the refrigerator door, restoring electrical connections for door-mounted components. Use this harness to replace a damaged or corroded door connector and regain reliable electrical contact. What it does:

• Provides the sealed electrical connection between the cabinet wiring and the door harness
• Restores power and signal to door-mounted parts such as switches, lights, and dispenser controls when the original connector fails
• Prevents intermittent or lost connections caused by worn, damaged, or corroded terminals
• Maintains proper connector alignment and strain relief for the door wiring

• One connector door harness

• Always disconnect power to the appliance before beginning any repair
• Installation typically requires removing the door panel or inner liner to access the connector
• Inspect mating terminals and wiring for damage; replace or repair any frayed wires before reconnecting
• Ensure connectors are fully seated and secured; test door functions after reassembly

This adapter mounts the fan motor to the appliance, keeping the motor securely positioned so the blower wheel runs true and airflow remains consistent. Replaces a damaged or broken motor mounting adapter to restore proper fan alignment. What it does:

• Secures the fan motor housing to the appliance cabinet so the blower wheel stays centered
• Helps prevent motor wobble or misalignment that can cause noise or reduced airflow
• Commonly used when vibration, scraping noises, or poor cooling/heating are present
• Works with the matching fan motor and blower assembly for correct operation

• One fan motor mounting adapter

• May require basic hand tools; disconnect power before starting any repair
• Inspect surrounding mounting points, fasteners, and the blower wheel for damage while replacing
• Retighten screws to manufacturer torque recommendations and test operation before final reassembly