Refrigerator Adaptor Or Connector

Adapter for upgrading from metal canister to modern cartridge water filters. Install once when switching filter types—reusable for future changes.

Note: 90 degree elbow coupler (Fits 5/16" diameter tubing on each end) For 1/4" elbow connector, order part# 4932JA3009A.

Water line check valve connector for refrigerators. Installs between water supply lines. Replace if leaking, cracked, or causing water connection issues.

Motor coupling adapter connects ice maker motor to drive mechanism. Replace if cracked, stripped, or broken to restore proper connection and operation.

Replacement water line connector for side-by-side refrigerators. Connects water supply tubing to inlet valve. Replace if cracked, leaking, or damaged.

Replacement wire harness connector for refrigerators. Restores secure electrical connections between wiring and control components. Needed when damaged or worn.

Water pipe connection assembly for refrigerators. Installs between water supply and internal systems. Replace if cracked, broken, or leaking.

Water line fitting for refrigerator ice maker and dispenser connections. Replace if cracked, leaking, or broken to restore proper water flow.

Water line fitting connector for side-by-side refrigerators. Replaces cracked, broken, or leaking fittings that connect water supply lines.

Replace your refrigerator's water line fitting adaptor if the connector is cracked, broken, or leaking. This fitting connects water supply lines securely.

Wire harness connector for refrigerator electrical systems. Replaces damaged, corroded, or loose connectors. Installs on internal wiring harnesses.

Quick connect adapter for refrigerator water line tubing. Installs between water supply and filter or dispenser. Replace if cracked, leaking, or broken.

Rear panel connector for refrigerators. Installs on the back panel to connect components. Replace if cracked, broken, or missing for proper assembly.

This rubber grommet seals and cushions the dishwasher water tube where it passes through the tub or panel, helping prevent leaks and reduce tube movement. It's a small but important part for reliable water routing. What it does:

• Creates a watertight seal around the water tube to help prevent leaks and water damage.
• Cushions and secures the tube to reduce vibration, rubbing, and wear.
• Helps keep the water tube properly routed and positioned during operation.
• Commonly replaced when you see leaking near the tub, water pooling under the unit, or a loose/misaligned tube.

• One rubber water-tube grommet

• Disconnect power and shut off water supply before servicing the appliance.
• Access the area per your model's service instructions (lower kickplate or cavity panel removal may be required).
• Remove the old grommet and press the replacement into the tub or panel opening; then re-seat the water tube through the grommet until it fits snugly.
• After reassembly, restore power and water and run a short cycle to check for proper routing and leaks.