Refrigerator Latch, Catch, Lock Parts

Ice bucket won't stay in place or dispenser not working? This latch assembly secures the bin and aligns it with the auger. Snaps in by hand in minutes.

Replace a lost or broken refrigerator door lock key to restore security and access. Simple replacement takes just minutes with the right key.

This replacement magnet is used in select refrigerator assemblies. It provides the magnetic hold or sensor trigger required so doors, flaps, or rails stay closed and so the controls can accurately detect when components are in position.

• Supplies magnetic retention in the specified assembly to keep parts closed and aligned
• Activates magnetic reed sensors in models that use them for door/position detection
• Weak or missing magnets can lead to door-ajar alerts, air leaks, or components not staying shut
• Visible damage or incorrect orientation can cause intermittent operation or improper sealing

• Disconnect power before servicing; turn off water if working near the dispenser
• Use your model's parts diagram to locate the magnet and note its orientation/polarity
• Press-fit into its holder carefully; do not chip or crack the magnet
• Verify proper closure/sensing operation before returning the appliance to service

Fix a refrigerator door that won't close or stay shut with this door latch. Simple repair that restores proper door seal and cooling efficiency.

This door latch secures the refrigerator door to help maintain a tight seal and proper temperature control. It replaces a worn or broken latch to restore normal door closure and reduce cold air loss. What it does:

• Secures the refrigerator door in the closed position to help maintain internal temperature
• Prevents the door from popping open during normal use or when bumped
• Helps reduce frost buildup and energy loss caused by a door that won't stay shut
• Fits into the door/frame assembly and engages with the strike to hold the door closed

• Disconnect power to the appliance before starting any repair to avoid electrical hazard
• Inspect surrounding gasket and strike for damage; replace if necessary for proper sealing
• Use basic hand tools (screwdriver) and take care to retain mounting screws and any clips

This magnet assembly replaces the magnetic strip that helps the refrigerator door seal stay tight, improving door closure and helping the appliance maintain proper temperature and efficiency. What it does:

• Replaces the magnetic sealing strip in the door gasket to help the door stay closed
• Restores a strong door seal to reduce cold air loss and limit frost buildup
• Helps prevent warm-air leaks that can cause the compressor to run more often
• Addresses symptoms such as a door that won't fully latch, visible gaps at the seal, or excessive frost in the freezer

• Disconnect power to the appliance before beginning any work
• Remove door trim or gasket; the magnet may snap or slide into a channel or require adhesive
• Handle the gasket and magnet carefully to avoid tearing or misalignment; ensure the magnet sits evenly along the door edge

Ice bin won't stay closed or falls open? This refrigerator ice bin latch secures the ice container. DIY-friendly repair with basic tools in 15 minutes.

Fix a freezer door that won't stay closed or latched properly with this door lock catch. Simple DIY repair to restore secure door closure in minutes.

Fix a refrigerator door that won't stay closed or seal properly with this door latch. Simple repair restores proper door closure and temperature control.