Refrigerator Shaft Or Pin

This replacement key pivot is the small pivoting pin that supports the refrigerator/freezer door key or latch mechanism, restoring secure pivoting and smooth operation at the key location. A direct-fit OE-design replacement. What it does

• Provides the pivot point for the door/key mechanism so the key or latch rotates smoothly
• Restores proper alignment when the original pivot is worn, bent, or broken
• Helps prevent a loose or wobbly key or a latch that fails to engage
• Works as a simple, serviceable part of the door/lock assembly

• One key pivot

• Disconnect power to the appliance before beginning any repair
• Remove door trim or access panel as needed; keep small parts organized
• Replace the pivot and check movement; avoid forcing parts that do not align

A small spring-style cotter clip that secures shafts and pins to keep moving parts in place. Restores a secure fit to linkage, rods, and pivot points so components stay aligned and don't slip free during operation. What it does:

• Holds shafts, pins and rods in position to prevent components from sliding off
• Provides a spring tension lock around a grooved pin or hole for reliable retention
• Commonly used on linkage, pivots and fastener pins where a compact retaining clip is needed
• Helps stop rattling, loose connections or parts that drop out of place

• Disconnect power before servicing any electrical appliance and work with the appliance in a stable position
• Use needle-nose pliers to spread and install the clip over the pin groove; ensure it seats fully
• Inspect mating pin/hole for wear or damage and replace if deformed
• Replace with an identical clip size and style to maintain secure retention

This replacement plunger restores proper valve action in your appliance's water/ice system so the dispenser and ice maker control water flow reliably. It provides a simple, low-cost fix for valve sticking or worn internal parts. What it does

• Moves inside a water/valve assembly to open and close water flow for the dispenser or ice maker
• Helps stop continuous or unwanted water flow when functioning correctly
• Can correct symptoms like slow or no water dispensing, intermittent flow, or ice maker fill issues
• Works as an internal service part when the valve is disassembled for repair

• One plunger

• Disconnect power and shut off the water supply before starting work
• This small internal part requires valve disassembly; follow the valve manufacturer or service manual for safe removal and reassembly
• Inspect valve seals and springs during service; replace any damaged components to ensure a reliable repair