Refrigerator Terminal Block, Receptacle Parts

This wire harness replaces damaged or burnt wiring to restore safe, reliable connections between the control and the components it serves. Install it when the original harness shows heat damage, broken conductors, or loose/brittle connectors.

• Carries power and signals between the control and connected components
• Replaces frayed, burned, or corroded wires and terminals
• Helps address intermittent operation, a non-working load (motor, pump, heater, fan), error codes for open/short circuits, or a burning odor
• Restores proper routing and insulation where the original harness was compromised

• Disconnect power before servicing; shut off water or gas if applicable
• Photograph routing and connections; move any clips/retainers to the new harness in the same positions
• Seat connectors fully without forcing; avoid pulling on wires or bending pins
• Route away from sharp edges and heat sources; secure with existing ties/retainers to prevent chafing

2 wire insulator.

This lamp set replaces the refrigerator interior light assembly to restore illumination for easier food visibility and safe access. A direct-fit replacement that reinstates normal lighting when the original lamp is burnt out or damaged. What it does:

• Provides interior lighting so shelves and contents are visible.
• Replaces a broken, burned-out, or flickering lamp to restore consistent light.
• Works with the existing housing and door switch to activate when the door opens.
• Improves safe access and helps prevent missed spills or spoiled food due to poor visibility.

• Disconnect power before servicing to avoid shock—unplug the appliance or shut off the breaker.
• Remove the old lamp cover and assembly, then swap the socket and lamp with the replacement.
• Handle bulbs carefully; use a cloth or gloves to avoid oils on the bulb surface.
• Test the lamp by restoring power and opening the door.

This lamp socket is the bulb holder used for the refrigerator interior light, providing a secure electrical connection so the interior lamp stays lit when the door is opened. Replaces a worn or cracked light socket to restore reliable lighting. What it does

• Holds and connects the interior light bulb to the refrigerator wiring.
• Restores intermittent or non-working interior lighting caused by a damaged or loose socket.
• Prevents flickering or poor contact between the bulb and the appliance wiring.
• Fits into the existing light housing to maintain correct bulb position and illumination.

• Always disconnect power to the appliance before starting any repair.
• Remove the bulb and light shield before replacing the socket to avoid breakage.
• Check wiring and connectors for damage; replace or repair wiring if frayed or corroded.
• Use basic hand tools.