Refrigerator Tank Ce Small Engine Regular Starter Parts

• Won't start

Noticed Rolls on the top shelf no longer frozen, though the meat around it still was. Note: This is a good test, keep something that thaws quickly and is not expensive on top shelf, to act as a barometer for your freezer health! I first found a trip online to advance the defrost timer, as a failed timer is a common issue. I advanced the timer, but nothing happened. I emptied the freezer, then removed the thermostat and tested it. No continuity! With the Freezer continuing to thaw, I... Read more

• Clicking sound
• Won't start
• Freezer section too warm
• Fridge too warm

Removed back cover and installed new start device. Plugged in refridgerator and it runs like new. Read more

• Won't start
• Too warm
• Fridge too warm
• Freezer section too warm

In short - I replaced the evaporator fan motor and the evaporator fan blade. The Appliance Parts Pros website was extremely helpful to me. Here's how. 1. The site helped me identify that even though my Freezer says it's a Frigidaire, it's actually an Electrolux. 2. The site identified the potential screech causing parts. (I didn't take a chance, I bought all three) It was a worthwhile investment. My freezer is 20 years old so it deserved some help. 3. The site provided guidance videos (not... Read more

Our refrigerator takes care of my wife and I, along with our children when they visit, and the grand kids. Over the years, it's seen its fair share of wear and tear. Thankfully, nothing major has happened that hasn't been able to be repaired right here in the home, and by me. Our refrigerator is a GE side-by-side with an ice maker/water dispenser, and has held up well. I've ordered parts for it from AppliancePartsPros.com for all of its repairs, and while GE/Frigidaire have been changing out a... Read more

Replaced the starter and capacitor, 30minutes, $60.... Bam!!! Fixed Read more

I had a slow leak at the water inlet valve where the water line from the filter assembly connected to the water inlet valve. I determine that the water line had scratches in it which caused it to not seal. Had to buy the entire reservoir and filter assembly to get that water line. The replacement was smooth. It took about 30 minutes to swap out and it fixed the leak. Read more

• Fridge too warm

Replaced the Thermistor Assembly and also picked up Overload Protection circuit per the comments posted by the "experts" on the web site. Both parts cheap enough. I ordered parts at 3:30 in the afternoon and they showed up the next morning from half way across the country. Outstanding service. It also fixed the 9 year old refrigerator. Replacing the parts took about a half hour most of which was moving the unit from the wall and removing the panel to get at the parts. Read more

WENT TO YOUTUBE FOUND OUT HOW TO TEST THE COMPRESSOR IT TESTED GOOD SINCE IT WAS NOT THE COMPRESSOR I ORDERED THE PARTS THAT WOULD MAKE IT WORK AGAIN - THE CAPACITOR & OVERLOAD PTCR COMBO I INSTALLED THE PARTS NOW I HAVE A FRIG. THAT'S WORKING AGAIN.AT A FRACTION OF THE COST TO REPAIR- THANK'S TO YOUTUBE. Read more

Thanking APP ahead of time for expedient 1 day express parts & videos! I kept a LOG on this repair fix starting 6/21/20: started with cleaning out behind the Frigidaire /coils, fan blade, floor, walls, toe-plate, compressor. #1 Replaced just the Run Capacitor [from my local appl store]. Somewhat better but not a fix. Fridge controls need much higher settings than Factory Settings - which is recommended. Did some homework on several sites /kept coming back to yours / saw what parts are probably... Read more

• Leaking

Replaced tank assembly. Actually I think the supply hose was originally not fully seated in the tank and I think I could have re-seated it deeper through the gray bushing. When I set the line into the new tank, still leaking. Pulled out supply line and reset using a little more force and line went into the tank. Took the bushing clip off the other tank and used it for the supply line bushing. So far, no leaks. The thing to remember is to push the edges of each hose bushing inward to pull... Read more

• Won't start

Refrigerator made a clicking sound in box connected to compressor. Googled it and found the reason could be the 2 parts I ordered. Replaced them and it runs fine now. Read more

Took a bit to diagnose. First tried cleaning coils but the problem still persisted. Next took of the back panel and put the system into diag mode. (Press energy save button and fridge button for eight seconds system ding once a second and inverter board red LED will blink a code or be on solid if no issue. See back of the refrigerator for a sticker with what the number of blinks means. My unit one blinking 1 time. So I measured the resistance of the compressor between windings (8.9 ohms between... Read more

Water dispenser came down to a trickle and made a lot of noise, I changed the filter but it didnt help and thus the water tank/head assembly needed to be replaced. Replacing the water Tank/head assembly was an easy task, the hardest part is removing the covers and taking care of not breaking the insulation of the water inlet hose. For the not-so-experts like me it is also good to rememebr to have a bucket to collect all the water that comes out after the connection to the solenoid valves is... Read more

GE refrigerator 12 years old and we love it. Ordered compressor overload and compressor start relay video's were great made the replacement easy. I also ordered the control board because I felt this was the real culprit again the video was the best. With all the parts replaced GE profile refrigerator has been working like new. Thank you AppliancePartsPro.com Read more

• Won't start

First I have an LG French Door with a bottom freezer. It quit cooling. I went on line and watched some very informative You Tube videos. I trouble shot according to these videos. In these videos it shows that if there is a click coming off the compressor it has too meanings, the compressor is froze or the start relay is bad. I ohmed the compressor and had no open wires in the compressor. I then shook the relay and it was making noise. The videos stated that is there is a noise in the relay... Read more

After watching installation videos on each felt I could pull it off and ordered and received replacement water reservoir and water dispenser tube assembly. Reservoir installation went off without a hitch outside of the added step of the need to remove the entire main in waterline assy in order to access the connectors which also were not as represented in video, in that they were not the press-to-release type but standard threaded compression types. Water Dispenser tube/spout assembly was much... Read more