Gy396lx802 Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Oven not heating evenly
• Little to no heat when baking
• Element will not heat

I began by turning off the breaker. I then removed the screws securing the bake element. I immediately noticed only one side was wired and the other side was burned off. The wire for the burned off section had fallen through the hole in the back of the oven. I tried fishing it out to no avail. I removed two side trim screws, the side trim pieces, and two screws holding the built-in oven into the wall. I was able to slide the oven out and onto a square stool that was the correct height. I... Read more

• Oven is too hot
• Oven not heating evenly
• Little to no heat when baking
• Won't start

I have a Whirlpool RBS245PDQ12 wall mount oven. Gathering information from AppliancePartsPros.com resulted in two possibilities: The Thermal Switch or the Control Panel. Talking with Appliance Parts Pros led to testing the Oven Temperature Sensor. It's supposed to test at 1080 Ohms at 70 degrees Fahrenheit. Mine tested at 960 Ohms so I knew it was bad... I found the service manual on the top of the Oven on the left behind the control panel. It has values for testing (Ohms of resistance)... Read more

Took the stove apart*, saw where the mouse had made a nest. It was kind of like a hotel room after a rock star had used it. It was nasty, is what I'm saying. I removed the insulation, which immediately went into a garbage bag and was placed outside, whereupon I took off and nuked the site from orbit. It was the only way to be sure (actually it was disposed of in the proper manner, no nukes were detonated in the course of this repair). Anyway, I ordered the insulation from this site, which was... Read more

• Little to no heat when broiling
• Element will not heat

Found a real cool Youtube video by AppliancePartsPro.com. I watched it and learned how easy it was to unhook and replace the part with proper care and precautions. It even included tips on critical steps so the wires won't slip back inside the hole and save you from hours of possible mistake. Then I ordered the part. It came the day after, then I replaced the part, meaning, I DID THE WORK! (My wife was so impressed- lol) Easy as pie... but we made and had a much nicer roast the day after.... Read more

• Won't start
• Element will not heat
• Little to no heat when baking

This is for the Whirlpool in-wall double oven GBD307PDS10. No power and the door locked after the shutdown before the self-cleaning cycle was over. I watched some video and this is a known issue the fuses blow during self-cleaning. I opened the door with a 90-degree hook, an easy task. Took doors off (watch video from others), unscrewed from the wall, and made a very small platform. and took the oven out (need two people and take the doors off first. The doors are heavy and you won't lift the... Read more

Replacing the Door Gasket is very easy and will take about 2-3 mins per door. Simply remove the Gasket Retainer (1 screw), and pull off the old Gasket. Install the new gasket by simply pushing the gasket clips into the holes where the old clips came out from. Be sure to start gasket at the first hole either side of the Gasket Retainer and work your way around. Reinstall Gasket retainer. The Door Insulation is a very involved repair, and best to follow specific repair manual instructions. Door... Read more

• Won't start

I was going to just throw my stove out and get a new one until I did some research. I stumbled onto this site and found my broken part watched a quick video thanks to this wonderful site, they convinced me I could do it. I ordered the part on a Saturday night and Tuesday I got my part I was shocked. Took 5 minutes to fix and this site saved me hundreds of dollars on buying a new stove. Would buy again from this site in a heart beat. Thanks appliance parts pros! Read more

Touch up paint Read more

Replaced It With New One Read more

• Element will not heat
• Won't start

Turned off power supply. Removed two screws (near the oven door) holding the ceramic top. Slid the top forward, disengaged the two power supply cables, and removed one ground wire. Removed range top, and put on a flat surface. Unclamped two power supply wires, one ground wire and one thermocouple wire from the element. Unscrewed the bracket from the element, and remove the element from the range top. Remove the two clamps from the old element, and put them on the new element at the same... Read more

I watched a YouTube video prepared by someone at Appliance Parts Pro. Then I did a live chat to get the part ordered. It came 4 days later and that night my husband and I fixed it. Awesome! Thanks Appliance Parts Pros! Read more

• Noisy

Followed the video- opened the front of the dryer and removed the drum. It was evident that one of the wheels had worn and wasn't turning freely like the other one. The video showed how to remove the roller. Very simple process and now the dryer works just fine. Read more

I am a 42 year-old, reasonably handy woman with limited strength and a little arthritis in my hands, and I managed this all on my own, just. fine. Prep: Put an old blanket on a counter, because you will need to put the door OUTSIDE UP, INSIDE down on it with the hinges dangling over the edge of the counter. You will also need degreaser (I used straight white vinegar) if you want to clean things up while you have it taken apart. You will also need glass cleaner (or use vinegar and a microfiber... Read more

Great, I had my two new hinge door's put on in about 10-15 minutes Read more

I ordered a new socket and replaced the socket and now we have a light in the oven. The project took about 10 minutes and was easy done. Read more