Lat50066aae Parts

First replaced the drum rollers...that wasn't it..took dryer back apart and spun the belt tension wheel by hand (should have done this the first time I took the dryer apart) and it squeaked. so I ordered the full parts: wheel, idler arm, idler spring, arm sleeve, E ring..Put it back together and whoa..no more squealing!! Read more

Removed the front panel and removed the screw from the console which revealed a broken plastic tab on the right side of the old injector. Replaced the old injector with the new one and that took care of the problem. Read more

Replaced mounting stem and tub bearings Read more

• Lid or door won't close

The lid shut-off switch is located behind the lid How About That. I order the plastic ball the hold the lid in place plus the lid shut off switch. I watched the video that AppliancePartsPros.com has on how to replace the lid and the plastic balls. I removed the lid to get to the two philips head screws to remove that part of the shut-off switch. I took the new switch out of the package and compared it to the old switch. I assembled the switch just like the old switch look using the new... Read more

Replaced flow meter and control valve Read more

• Noisy

Replaced them. Read more

Ordered a replacement valve and installed it. The part from AppliancePartsPro was an exact replacement for the original part. Replaced the hot and cold hoses at the same time to insure no leaks. Cold water settings now work properly again. Read more

Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more

• Shakes and moves

New leveler pads Read more

• Shakes and moves

Took off the old parts and replaced with the new parts Read more

Removed front of washing machine, loosened clamps, got wet, replaced hose, tightened clamps, tested hose--no leaks--job done. PLEASE, PLEASE put up a description indicating the length of hose, measured along its length, is 15." It will save other folks wondering if they ordered the wrong item. Thank You. Read more

I bought the $6.00 plastic clip that holds the agitator In place while washing and the $10.50 spanner wrench that takes the 2 top nuts off to get to the agitator stem the other tools necessary for the job which are just a couple of things I already had then watched the video on line of how to do the job and then did it the whole thing took about 2 hours plus I took my time and gave both tubs a very good cleaning. I paid a guy $400.00 9 months earlier to do the same job wish I hadn't, should... Read more

• Leaking

Took off cover, installed new parts. Read more

Model# MAV7257AWW Maytag Atlantis Washing Machine. Repairs were fairly easy along with the videos appliancepartspros offers on their website. Parts also came with instructions on how to install. Other videos were available on You Tube. The only part difficult to install was Thrust bearing kit - make sure when installing to pull down on shaft so washer and e-clip will fit. Another note, you can get a pulley for your replacement motor pulley on eBay and Maytag.com. Just pay close attention to... Read more

Removed the old tub cover/gasket by removing the front panel and top lid. Then, unclipped the tub cover. Read more

Simple. Remove top back panel. (4 screws) Remove old injector. (1 nut screw.) Rotate to remove. (Other side is a tab in a slot.) Unsnap the upper injector. Snap upper injector on to new lower injector. Replace in reverse order. Run washer, look for leaks. Read more