We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Microwave won't power on or turn on? Failed thermostat causes complete power loss. This safety part protects against overheating. DIY repair in 30 minutes.
I attempted to diagnose the four thermostats/thermal switches in the microwave....two right behind the control panel, one on top of the cooking cabin, and one under a metal shroud above the magnetron. While checking continuity with a voltmeter, i questioned one of them behind the control panel and the one above the magnetron. I then noticed a burn mark on the plastic connector sleeve for the one above the magnetron. I took a scrap piece of 14 gage copper wire and beat the ends flat with a... Read more
Fix a microwave that runs but won't heat with this high voltage diode. Converts AC to DC power for proper heating. Typical DIY repair in under 2 hours.
I am not an appliance repair man. I am a general surgeon. I went online and researched the problem. The consensus was that my magnetron and diode were the most likely culprits. To replace my microwave with a comparable model would have cost at least $800. The diode and magnetron cost around $170. I watched a few videos on YouTube demonstrating how to do the repair safely and I felt like I could do it. I ordered the parts on a Monday evening and had them Wednesday. The only difficult part of... Read more
Microwave turntable won't rotate or makes rattling noise? This motor drives the glass tray for even heating. Easy 10-minute DIY fix with basic tools.
Obtained the replacement motor and tray coupler from Appliance Parts Pro. Video of the typical replacement was very helpful to show what to expect and how to replace the motor and coupler. The removal of the bottom plate was held in place by several phillips screws. The motor was attached with two torx screws. The electric connection clips to the motor required needle nose pliers to pull them off. The tray coupler was simple to install after the motor was secured and bottom plate was replaced.. Read more
This is a light lens cover that fits over the surface light bulb housing on the underside of an over-the-range microwave. It protects the light bulb and diffuses light onto the cooktop below. Replace this cover if it is cracked, yellowed, missing, or if it no longer snaps securely into place.
When the new bulb didn't want to go in, I felt around and realized the base of the old bulb was still in there. With some effort I got it out and new bulb in, Light cover fit fine, but did not come with a screw to hold it in. That would have been helpful. Read more
Microwave won't start or runs only when door is pulled? Replace faulty door interlock switches. This 2-pack covers top and bottom switches. DIY repair.
First, it was going to cost $95 for an appliance guy just to look at it! I figured there would be an upcharge on the parts + labor on top of the $95, so I took a chance & decided my husband & I could fix it cheaper; we were right, but it was a 3 week process (luckily, we have another microwave in the basement we were able to use in the meantime). I googled the microwave model #, then price checked the same item I thought we needed; printed off the diagrams of the various microwave "systems" &... Read more
Microwave not heating but still running? The magnetron controls heating function. DIY repair in under 2 hours with basic tools and multimeter testing.
Includes brackets, screws, and fasteners for secure microwave installation. Replace missing, lost, or incomplete hardware from floor models or clearance units.
I ordered the mounting bracket, mounting hardware and template for the top cabinet. Everything I ordered was an exact fit. Install only took about 30 minutes after running the new electrical for the microwave. Appliance parts helped me save almost $400. Read more
Supports the glass tray and enables smooth rotation in your microwave. Replace when worn, cracked, or causing noise to restore even heating. Confirm fit.
Put in the ones I ordered. Read more
Black grill vent cover for microwave and microwave/hood combo units. Installs over the filter area. Replace if cracked, broken, or won't sit flush.
I identified the name of the part from the manual diagram, typed it into AppliancePartsPros.com, double-checked the model to make sure it would fit (thank you, thank you for provide that double-check feature, which I'm sure has saved many other customers the trouble of shipping back the wrong parts and reordering the right ones), found a "how to" video on youtube, and set to work. I ended up having to replace the grill vent as well as the two filters behind it, because part of the grill vent... Read more
Self-tapping screw used in range assembly. Features 8-18 thread size and 0.375 inch length. Also used in some washer models as cross-appliance hardware.
I replaced all three baffles since the new one was a different design than then old one. i watched the video and the repair went well, except for hitting my hand with a hammer while removing the old baffles. went just like the video said it would Read more
Microwave won't heat or is completely dead? A failed thermal cutoff thermostat often causes no power or heating. DIY repair in 30-45 minutes.
Watched u-tube Read more
Microwave won't heat or makes loud buzzing noise? The diode regulates magnetron current flow. Simple repair—test with multimeter for continuity.
I have a multimeter so I was able to check the fuse per website recommendations and it was blown. However, the capacitor on the microwave was also original so I elected to replace the capacitor, fuse, and the ground protect diode. The repair was very simple (making sure the capacitor was discharged before replacing) and the microwave is now up and running again. Excellent trade to buy $40 worth of parts rather than a new $400 microwave. One nit - Kenmore puts a screw in the back that... Read more
This holder assembly secures the locker/latch mechanism in place so the door or access panel aligns and closes properly. Replacing a cracked or missing holder restores secure engagement and smooth, reliable operation. What it does:
Parts diagram indicated that the microwave door when closed, turned several switches on. I replaced all the parts that were associated with the door lock. Also while there, put in a new charcoal filter. Read more
Fix loud noise, humming, or overheating in your microwave. This cooling fan motor restores proper airflow. Moderate difficulty repair with basic tools.
Looked online and found that someone had experienced the same issue and had replaced the cooling fan assembly for the magnetron. I ordered the parts for the assembly (motor, fan, and support), and replaced them and this fixed the problem. It took about 10 minutes to replace the parts, but lowering the unit and disassembly took around 45 minutes. The most difficult part was getting the outer sheet metal cover back on after the repair, as it has a bunch of clips on each front edge that need to... Read more
This door interlock microswitch detects when the microwave door is fully closed and allows the unit to run only under safe conditions. Replacing a worn switch restores reliable starting and consistent operation tied to the door latch.
Utilized a YouTube video to isolate the door switches as the issue. These were easily identified following the isolation process and simple testing. I ordered a door switch and secondary switch on Monday and they arrived on Tuesday via FedEx. 15 Minutes to re-install, re-assemble cover and the unit was working fine. A very good experience with parts availability and shipping. Read more
Microwave won't turn on or has no power? A failed thermostat often causes complete power loss. Moderate DIY repair requires disassembly to access.
I checked for the reasons there was no power to the microwave. Then I talked with the technician at AppliancePartsPros who stated that it was most likely a blown or defective fuse. My LG microwave has two thermal fuses, a fuse assembly with two prongs and a short (1 inch) barrel type fuse. I replaced all of them after viewing YouTube videos and then reviewing the diagram for my microwave on the AppliancePartsPrps website. That was very helpful in locating where the fuses were installed. It... Read more