Sgv55m43eu/10 Parts

I spent a lot of time taking apart and cleaning the drain pump and hoses in my Bosch dishwasher. I still got the error that the drain pump wasn't right. So, after doing some research, I learned that the motor might be done and that seemed to be the only solution. I serached for my part on APPs.com and found the part for about $43 ($50 by the time tax and shipping was added in). The part was ordered, shipped and was on my doorstep in two days. I followed the repair video instructions provided... Read more

Popped on the new one, very easy Read more

Ordered a new filter. Read more

I changed the control board (00498022) in the door of my Thermador dishwasher. Thermador, Bosch, and Siemens all use the same board for the indoor controls and display. This required a #15-star head driver to remove the screws. I used an impact wrench (set to a low torq setting) to speed things up. There are approximately 12 screws to remove. Two are long. The rest are short. Be careful to hold the door together as the last screws are removed. Everything comes apart easily and you do not... Read more

In order to replace this, you must remove the "outer door". This service manual is a pretty good reference (page 37): http://members.msaworld.com/wp-content/uploads/sites/3/2017/02/2013-DW-Service-Manual.pdf Note that this specific dishwasher has 12 screws that need to be removed before the outer door can be separated. Once separated, don't even bother trying to push the broken handle out of the front as suggested. You will probably end up damaging the outer door. Instead, take some... Read more

• Will not dispense detergent

Process was a bit more complicated than the videos I had watched online. Had to remove both front panel and control panel to get to soap dispenser. Removed wires to soap dispenser and rinse aide dispenser. Removed wire "harness" around the top and right side of dispenser. Pried back the clips to allow dispenser to be pushed out. It was helpful to have another person to hold the door open at this point. Bent clips back and reinstalled everything. New part works great. Read more

I bought just the replacement lid based on other reviews. The door cost about a third of the whole soap dispenser module but took a chance it was just the lid. Although the part number is the same there was a new flange on the inside of the lid. Would have been nice if Bosch sent the redesigned part to owners. Either way replacement took 2 minutes and the problem is gone Read more

Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more

Bought new wheel and the are easy to replace. Found why the brok and did a quick fix so it wont happen again. As the wheels age one will pull off then they all get weak and the rack will come off the track, To prevent this. you can put a plastic tie so the wheels cant fall off in the first place, The disign holds them in place with pressure from the plastic but the plastic ages and gets weak. A tie would have to actually break before the wheel can fall off. Read more

Replaced dispenser Read more

Twist the old one out, insert tab, twist until other side snaps in. Easy as pie after watching the video! Read more

• overflowing

This was not my first rodeo have repaired our appliances and those of our daughters for years, have ordered parts from this site several times. We had a cold spell in Texas, as you may have heard. We weathered it okay but left the dishwasher closed on one of the colder nights, woke up to water on the floor in the kitchen. Turned off the supply line, shut off the dishwasher power, bailed out the bottom, and mopped up. Had a fair idea of what the cause was, checked a few websites, watched some... Read more

Got new replacement spring and cord for our Bosch compact dishwasher. A plastic retaining bracket that held the old spring also was broke but the new spring had its own piece that fit into a slot in the plastic frame, so i just popped it in there, connected the cord, and bingo. The door now works. I tried using the old spring, but it would not work because of the broke bracket. Read more

Leak was slow but becoming gradually worse. Pulled dishwasher out from under counter then visually inspected sump while it ran. As soon as the water got very hot, I could see the sump leaking where it meets the stainless pan. Searched for the correct sump gasket without success. Turns out that the gasket is built into the sump for this model. The built-in gasket is very narrow (under-engineered IMHO which is probably why it developed a leak). Thanks to Simon's excellent videos at... Read more

• lights flashing or blinking
• Will not drain
• Noisy

Water was left in the bottom of the dishwasher after each time we ran it and the dishes were no longer getting clean. Also, there was always soap left in the dispenser. I took the DW completely apart and determined the water was not being forced out of the discharge tube and was merely draining via gravity. I ordered a replacement drain pump and removed the entire motor/pump assembly from under the DW. Once the pump was replaced and the DW was put back together, the water now was forced out... Read more

I ordreded the tine clip kit. APPros was the least expensive, even with the shipping charge, and I had it in two days. Replacement piece snapped into place with very little difficulty. I also have extras from the kit so I am set if another breaks. Read more