Wsf26c3exbo1 Parts

I noticed Ice maker Quit for the third time in 15 years so I decided to buy another Ice maker, I installed it and NO ice still?? Well I went after the other problem thinking if it does not get cold enough maybe ice maker won’t work. I ordered Defrost Switch, Heater and Evaporator Fan just to be safe. I replaced all three, the fan was noisy, the heater OHM’d ok but I replaced it as did the defrost switch, I put it back together, the Freezer got to 0 degrees and the frig got to 38 degrees so I... Read more

Replaced a new rubber seal, it took me approx forty minutes. It works perfect, the door seals correct now. Thanks to the instruction supplied from appliance parts pros.com. Read more

The problem was that the motor coupler & shaft had a tiny bit of rust at their union. With the weight of the ice bin it rusted in the lowest position. This didn't allow the motor coupler to float on the shaft. There is a spring inside the shaft that pushes up on the motor coupler keeping it engaged in the ice bin coupler above. This coupler in turn rotates the auger in the bin to dispense the ice. I removed the motor coupler & shaft, tapped the coupler loose and filed off the rust. This allowed... Read more

Bought a new Snack Pan. Read more

Replaced all the parts ordered and adjusted door. Took about one hour to complete. Read more

• Light not working

I saw your video on you tube and it seems very easy to do it my self, so I ordered the parts and I did it my self. It was very easy. Thank you for sharing with us on how to did it. One more thing, the parts arrived on the time they said it would come. Read more

The replacement drawer came with a crack - manufacturing defect. I called the vendor and got replacement at my door NEXT DAY! No red tape at all! Read more

Found the parts in the diagram of my fridge and simply installed it very easy Read more

Replace front & rear wheels. Read more

Bought new optic control boards, both the emitter and the receiver. The repair process was so simple. The KitchenAid repair tech came out to diagnose our issue. He was only going to come back and install a new emitter. They wanted a lot of money to do the repair. They were going to charge us $257 just for the part (emitter board). We bought both boards for $300 from AppliancePartsPros. We decided to replace both boards, because if one went bad the other might not be far behind. Read more

Replaced broken handle Read more

Easy fix. Ordered a new defrost thermostat. Watched video. Installed a new one. 10 min. DONE. Read more

Remove and replaced the auger motor, shaft seal, and the chute seal. No problem. However, the causing failure was to broken wire on the bottom of the freezer door. Loom and blue wire were cut, due to being pinched. I had current to start with and the auger worked three times then quit. That's when I really had to start searching . Fun. Read more

• Leaking

Thought leak was coming from icemaker but refrigerator was making ice just fine. had puddle on floor just below freezer door. upon closer inspection realized leak was coming from drain line. there were 2 pieces of tubing and the connector. leak was coming from where tubing goes into connector. wanted to replace it. didn't know what it was called. did live chat with someone I think was named James. he sent me diagrams and I could identify the part. once identified I ordered it. boom.... Read more

Easy fix. Took two screws out of top door hinge. Lifted door off of bottom hinge. Laid door on blanket on floor. One cam part went on the hinge that was on the fridge, snapped in place. One cam part went on bottom of door, one screw to replace. Replaced door on bottom hinge then put top hinge back on. Job done. Read more

Replaced the ice bucket assembly. Read more