Tank Ce Small Engine Start Switch Parts

I had to pull and clean the pressure sensor switch four times in a year. Each time more gunk accumulated. When that happens the sensor does not close the water valve. The dishawsher keeps filling and the water comes out through the overfill port. The water then goes in the catch basin under the washer and floats the emergency switch. This cuts off the water but keeps the pump running just in case. Tripping the circuit breaker is only a temp fix. What happens is the water level may have... Read more

Part easily replaced and problem was solved. Saved service call. Read more

• Won't start

I was searching the web for solutions and came across two folks who had similar trouble code. One fixed his by removing the pump strainer from the pump to find coins blocking water flow, thus the analog water pressure sensor provided a failure response. My issue was solved by following the other hints I got. I ordered a new sensor (switch). It was expensive for what it is, but the washer will not run correctly without it! The part arrived in a very timely manner, and it was the right part.... Read more

Had to remove all three food drawers and the back panel behind the drawers (4 screws). The water tank comes with the associated tubing which would typically require access to the back of the fridge to run the new lines. Instead I clipped the existing lines inside the fridge. Then I clipped the lines off the new tank so they would line up with the old lines. I then used a 5/16" OD compression coupling (Lowes or Home Depot) to connect the ends of the tubing together. The joined tubes are... Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

• Won't start
• Fridge too warm

Took access panel off the back of the refrigerator with 1/4 inch nut driver and found that the compressor was not running properly (humming and hot but not compressing). The compressor cooling fan was working as well as the fan in the freezer compartment. I fixed the same problem with another refrigerator by replacing the relay and start capacitor on the compressor. I pulled these two items from the compressor connector (gently pry the brown part from the comp terminals first and then the... Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

Ordered the right part, took the back off the top control panel, and popped it in. Read more

Removed fill level pressure switch knob. Removed three screws from the back of the control panel.Opened the control panel and removed electrical connector and plastic tube from the pressure switch. Removed and replaced pressure switch. Placed control panel to correct position and replaced the three screws. Read more

Searched internet for answers. Decided to replace the door switch. Drier now runs great! Read more

• Won't start
• Freezer section too warm

Looked for obvious signs of mal-function, burned wires, etc. I found that the compressor controller(attached to the compressor) had an obvious burned-out spot. Took a chance that was the problem (it was); ordered all new OEM parts, including a new timer and run capacitor (a part that kicks in every time the compressor starts). I received the parts at 1 PM EST; by 1:48 PM I had the freezer working. Easily saved $250.00. A nice aside was that an Internet competitor was asking $53.00 for the same... Read more

Simple unplug, unscrew and replace. Read more

Initially performed troubleshooting over the phone with Bosch customer support and did preliminary research on the web. Ultimately had to call out service technician to isolate/confirm problem. He confirmed the problem was most likely the switch (if not, the actually computer processor) and gave me the part number (since it was going to take 10 BD's for him to get the part). I ordered through Appliance Parts Pros and received the part in only 2 days. However, upon trying to install it, I... Read more

So I ordered the burner and Ithe switch because I wasn't sure what part was defective. I pulled the oven out and I removed the 6 1/4 inch screws on each side of the glass top as well as the 2 Phillips head screws on the back, removing the 2 1/4 screws on the shield on the back gIves you easier access to them, then lifted the glass top up on the front to access the switch and burners. Make sure you turn the power off before beginning this process. When lifted up the wires connected to the... Read more

I had a friend and a repair guy tell me it was the start relay that needed to be replaced, which was an easy fix. My friend said just to unplug the start relay, replace it with the new one, and it should be good. I've never tried to repair a fridge, and that was the easiest repair ever. Saved us hundreds of dollars! Read more