Bake Element Msr5770aab Parts

First guess was the Bake Element, but I ran my hands around it and didn't feel any clue of a break/failure in the element. Further research indicated that the Hot Wire Relay is the next likely cause, that was really bad news because that part is unavailable anywhere. Swapped the H1 and H2 wires on the Hot Wire Relay, and found that Broil still worked, which indicated that the relay was good and the Bake Element was the likely cause. This was good news because that Hot Wire Relay is made... Read more

• Not drying dishes properly
• lights flashing or blinking

Number one was turn the power to the dishwasher off. I disconnected the hoses under the sink. The dishwasher had to be pulled out from the cabinet. The old heating element easily came out and the new one put in its place. The instructional video made the repair very easy. Read more

New part clipped right in. Tightened 2 screws and was done in 5 minutes. Read more

• Little to no heat when baking

I removed two screws at rear of oven, disconnected electrical connectors, and removed old element. When the new element arrived (on time), I connected the new element and replaced the two screws. The oven worked perfectly! The repair was extremely easy and cost effective. Read more

Installed replacement burner. Not a one-to-one fit where the wiring is concerned but everything needed to effect the change out was provided with the part. It is important to make notes of what was connected to what on the old one and to compare that to the new one. I used a download of the wiring diagram to good effect because it has the color code for the wiring on it. I am an engineer and can read such things which the average DIY'r might not be able to do so the notes will help. The... Read more

Used multimeter to diagnose no continuity through heating element. Took out element and found underwire from a bra (C-cup I think...) had shorted it and caused a break. Replaced heating element and ... still no heat. Found that one of the fuses had no continuity also. Replaced the fuse and everything working fine. Read more

Firstly, the Ice Door had a kink in the edge, which caused it to stay open and create lots of frost on the coils. $5.00 part, highly recommend it. (By the way, the new door was little too big and it too stay propped open and left a gap so I had to trim the top edge of the rubber with scissors to get it to fully close.) Secondly, there are two heaters for the defrost cycle, one that goes around the coils and another attached to a collector pan beneath the coils. When the cycle hits, those... Read more

• No heat or not enough heat

First, let me tell you that this is the fifth appliance I've fixed with parts and help from AppliancePartsPros.com -- At this rate I'll never get to upgrade to nice new appliances. :-( When my wife said the dryer wasn't heating up, I looked online for common causes before I even headed to the basement. A lot of people talk about the fuses going bad, so I figured that's what it was. Next, I watched the videos on how to get to the internals of the dryer. (I hate it when I try to figure it out... Read more

So I ordered the burner and Ithe switch because I wasn't sure what part was defective. I pulled the oven out and I removed the 6 1/4 inch screws on each side of the glass top as well as the 2 Phillips head screws on the back, removing the 2 1/4 screws on the shield on the back gIves you easier access to them, then lifted the glass top up on the front to access the switch and burners. Make sure you turn the power off before beginning this process. When lifted up the wires connected to the... Read more

Need to open because no parts’ numbers can be identified through their website. But the rest “order and put in” are very easy steps. Will come back if I do need other parts Read more

• Little to no heat when broiling

Removed 4" wide vertical panel that had two protrude contacts then remove the assembly that attach of 5 screws. then reverse process with the new one. Read more

First replaced defrost timer which tested OK - but reasonable price and easy to replace. When that did not fix the problem replaced the defrost thermostat and defrost heater. That fixed the problem. However all three parts tested OK ?? May have been a loose connection or intermittent problem with one of the parts. Final cost for all three parts was much cheaper than a service call!! Read more

Ordered the replacement part the recommended by your parts department. I then watched a video so I knew what was in Store. The part arrived in less than 2 days & 15 minutes later I was baking brownies!!!!! Voila!!! Done deal!!! Now I am going to order a second one to replace the lower oven's element since it's been 'off' for over a year. The local appliance repair had informed us that it would charge $125 for the initial 30 minute service call to come in to inspect the appliance,... Read more

I ordered the both the Pcb assembly and a heater sheath. Upon accessing the Pcb, I immediately discovered it had failed miserably, (contacts burnt and melted, wiring and insulation on one wire suffered severe electrical damage. To put it bluntly a small electrical fire had occurred on the circuit board. There was enough slack in the damaged wire so I removed the affected area, replaced the terminal. Replacing the Pcb was a snap. Disconnect the power, remove the rear cover, prior to removing... Read more

• Will not drain

Removed upper frig & lower freezer back evaporator covers to get to the frost buildup on the evaporator assembly. I then used a paint stripper heat gun to melt the ice build up caution should be used to keep the gun moving around as not to damage Wires,Eva,Sensor's. After 15 to 20 min of clearing frost I was ready to replace Drain Plate's & Thermal fuse's. When I had removed the old Defrost Thermal fuse's in the refrigerator & the freezer they looked different! They had an insulating foam... Read more