Hardware Hand Small Engine Regular Starter Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W10335056
Washer not filling properly or overfilling? A faulty water level pressure switch fails to signal correct fill levels. DIY repair in about 1 hour.
This part fixes the following symptoms
-
Will not stop filling with water
-
Will not fill with water
See more...
Do-It-Yourself Stories from Customers like You
Washing machine wouldn't fill water to the correct level it filled as if it were set to "small load" every time Jessica A. • Baltimore , MD • April 13, 2014
I took the washer apart and replaced the water level switch and hose with new ones. I followed the video that I found on youtube (which is on the site) and had no problems at all.
Read more
More
$59.48
- Compare At:
-
$70.19
- You Save:
-
$10.71
Genuine Frigidaire part
By: Frigidaire
Part Number: 316278700
Mounting screw for range oven door handles. Secures the handle to the door panel. Replace when stripped, corroded, missing, or if handle is loose.
Do-It-Yourself Stories from Customers like You
The door handle screw holes were hollowed out (the handle is plastic) making the door continuously fall off the plastic latches on the door trim were also broken off. Matthew F. • Columbia , MO • January 17, 2020
Replacing the trim takes a little bit of alignment and light force. The trim slides over the glass panel of the door, with the glass sliding into plastic tabs. We kept the door nearly vertical (almost closed), lined up the tabs on the trim with the glass door, and used mild force to slide the trim down onto the glass door. (Also, we found that the tabs on trim we ordered were much bigger than the tabs on our broken trim. This is probably due to slight variations in Frigidaire's design over...
Read more
More
$10.95
- Compare At:
-
$13.14
- You Save:
-
$2.19
Genuine Whirlpool part
By: Whirlpool
Part Number: W10821385
Includes brackets, screws, and fasteners for secure microwave installation. Replace missing, lost, or incomplete hardware from floor models or clearance units.
Do-It-Yourself Stories from Customers like You
Installation parts were missing, it was a display model Daniel G. • Rome , NY • May 30, 2019
With help from family we were able to install my microwave in just a short time.
Read more
More
$75.95
- Compare At:
-
$91.14
- You Save:
-
$15.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10350906
Dryer won't start or stops mid-cycle? A faulty door switch prevents operation when the door position isn't detected. Moderate DIY repair, 30-45 minutes.
More
$55.30
- Compare At:
-
$65.25
- You Save:
-
$9.95
Genuine Samsung part
By: Samsung
Part Number: DA34-10003S
Compressor won't start or cycles on and off every few minutes? This overload relay protects against overheating. DIY repair in about 10 minutes.
Do-It-Yourself Stories from Customers like You
Samsung dual cooling neither frig or freezer was cold Philip H. • Hazleton , PA • October 12, 2014
The compressor was very hot and did not appear to be running. You could here a relay click on and off 15sec cycle. repeating every 2 minutes!
Bought a new overload relay too repair, plus a new thermal protection switch because it was cheap.
Both parts are actually located on the compressor behind a plastic cover. Found part numbers for parts by searching the compressor number on google! $25 Repair............
Read more
More
$29.26
- Compare At:
-
$30.88
- You Save:
-
$1.62
Genuine Frigidaire part
By: Frigidaire
Part Number: 134813600
This door switch senses whether the appliance door is closed and signals the controls to run only when it's safe. Replacing a worn or intermittent switch restores dependable starts and proper shutoff when the door opens. What it does:
- Detects door position and allows operation only when the door is fully closed
- Interrupts operation when the door opens for safety
- Common symptoms include: won't start, stops when the door is moved, or "door open" message/error
- Intermittent starts due to worn actuator or internal switch contacts
What's included:
Install notes:
- Disconnect power before servicing
- Access the switch from the front or top panel; release mounting screws or tabs
- Move wires to the new switch one at a time to maintain correct positions, then secure the switch
- Test operation before reassembly
More
$49.95
- Compare At:
-
$58.94
- You Save:
-
$8.99
Genuine Whirlpool part
By: Whirlpool
Part Number: 279782
Dryer won't start but has power and timer works? This belt switch kit stops the dryer when the belt breaks. Moderate DIY repair, 45-60 minutes.
Do-It-Yourself Stories from Customers like You
Broken belt switch Jack F. • Hermosa Beach , CA • July 08, 2016
Every time I tried to start our dryer, the "Sensing Light" came on, I heard a little "click," and the dryer would not start.
According to the very helpful Appliance Parts Pros. videos, I was able to dismantle, diagnose a few components, and discover the broken part. In this case, it was a Broken Belt Switch.
I ordered the part, we went on vacation for a week, and when we returned home the part was at our residence. The next day, I installed the part and all is good now.
I am nearly 70 years...
Read more
More
$54.25
- Compare At:
-
$64.56
- You Save:
-
$10.31
Genuine Whirlpool part
By: Whirlpool
Part Number: 8205948
For mounting also consider WPW10269225 mounting plate
Do-It-Yourself Stories from Customers like You
We needed an assembly kit and turntable for wmh32517as 1 Jewell L. • Cincinnati , OH • March 01, 2015
We found the parts on this website. Thanks to your search bar, we could see if the parts would work on our model microwave.
Read more
More
$18.23
- Compare At:
-
$21.69
- You Save:
-
$3.46
Genuine Speed Queen part
By: Speed Queen
Part Number: D512973
Fix unresponsive or sticking control buttons with this panel-mounted push button switch. Restores reliable function activation. Straightforward repair.
More
$60.95
- Compare At:
-
$72.53
- You Save:
-
$11.58
Genuine Frigidaire part
By: Frigidaire
Part Number: 134813663
Dryer won't start or stops mid-cycle? This door switch detects when the door is closed, allowing your dryer to run. Simple DIY fix in 15-30 minutes.
More
$52.68
- Compare At:
-
$63.22
- You Save:
-
$10.54
Genuine Frigidaire part
By: Frigidaire
Part Number: 241707715
Fixes refrigerator not cooling with hum-click sound from compressor. This PTC start device energizes the compressor start winding. DIY repair in 10 minutes.
Do-It-Yourself Stories from Customers like You
Compressor would not start John M. • Hagerhill , KY • May 28, 2017
New start device.
Read more
More
$58.43
- Compare At:
-
$69.53
- You Save:
-
$11.10
Genuine Speed Queen part
By: Speed Queen
Part Number: D513505
This 3-position fabric selector switch is the control behind the knob that lets you choose the fabric setting on your unit. Replacing a worn switch restores positive detents and ensures your selection is recognized instead of ignored or stuck.
- Provides three selectable fabric settings to tailor operation
- Routes the chosen setting to the timer/control
- Typical symptoms: no response when changing settings, intermittent selection, or being stuck on one mode
- Physical clues of failure: loose/no detent feel, broken shaft, or heat-discolored terminals
What's included: One 3-position fabric selector switch Installation notes:
- Disconnect power before servicing
- Access the control console; remove the knob and retaining hardware to free the old switch
- Photograph/label wire positions and transfer each lead to the same terminals on the new switch
- Reassemble and test all three positions for proper engagement
Do-It-Yourself Stories from Customers like You
Dryer not heating Sandy H. • Burkesville , KY • January 14, 2017
Replaced the fabric selector switch. Took abut fifteen minutes. Dryer works fine.
Read more
More
$35.95
- Compare At:
-
$42.78
- You Save:
-
$6.83
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10330137
The Push Button Switch is an OEM part for Whirlpool washing machines. This part activates various functions and cycles on the control panel of the washer. The switch is designed to ensure responsive and reliable operation when selecting wash settings.
Causes of a bad push button switch can include wear and tear from frequent use, exposure to moisture, or physical damage from impacts.
Symptoms of a bad push button switch include:
- Unresponsive buttons on the control panel
- Inability to start or change wash cycles
- Intermittent operation of washer functions
- Error codes related to control panel issues
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Dryer was humming when pushing start button Chris K. • N. Wildwood , NJ • May 28, 2017
Removed front of dryer panel, removed top, and removed drum. Replaced motor and wheel, because the old wheel was rusted on the motor shaft, and could not be removed, so I had to break it off. Replaced motor, and reassembled. Everything works now. I also replace the switch-Pb, because the start button was getting stuck.
Read more
More
$229.95
- Compare At:
-
$273.64
- You Save:
-
$43.69
Genuine Whirlpool part
By: Whirlpool
Part Number: W10847984
Dryer won't start or tumble? This belt switch monitors drive belt tension and cuts power if the belt breaks or slips. Moderate DIY repair with video.
Do-It-Yourself Stories from Customers like You
Loud noise and squealing from bottom of Cabrio dryer. Mark B. • Goodyear , AZ • November 24, 2018
Remove bottom panel, remove top panel, remove drum. Had to cut old squirrel cage off. Remove motor to remove old wheel shank. Remove belt switch, and replaced. Videos from AppliancePartPros helped a lot..
Read more
More
$27.37
- Compare At:
-
$32.57
- You Save:
-
$5.20
Genuine Ge part
By: Ge
Part Number: WR07X10055
Compressor clicks on and off or won't start? This PTC start relay energizes the compressor start winding to restore consistent cooling. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
The compressor was clicking on and off refrigerator was blowing hot air inside Steve F. • Sealy , TX • May 27, 2017
I bought this relay switch and it works great. On the left side of the compressor there is a plastic cover you pry off with a screw driver. The relay switch had one wire plug on it. Just pull the wire off and the pull the relay switch off the compressor.
Read more
More
$28.55
- Compare At:
-
$34.26
- You Save:
-
$5.71
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304453707
This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.
- Fastens metal or plastic parts to the cabinet/frame
- Helps maintain alignment and reduce vibration or rattling
- Direct replacement for lost, damaged, or rusted hardware
- Keeps covers and brackets safely in place
What's included: 1 screw Install notes:
- Disconnect power before servicing; for gas appliances, also shut off gas supply
- Match one-for-one with the original screw; verify length/type before installation
- Start threads by hand to avoid cross-threading; tighten snugly without overtightening
- Use the correct driver bit to prevent stripping the screw head
Do-It-Yourself Stories from Customers like You
Ice dispenser not working auger not turning Roger H. • Chesapeake , VA • August 21, 2016
Replace dispenser micro switch. Also replaced broken faceplate and rusty screws. Appliance parts Pro YouTube video was helpful in diagnosis and disassembly. Parts arrived quickly.
Read more
More
$23.61
- Compare At:
-
$27.86
- You Save:
-
$4.25