Hardware Hand Small Engine Flywheel Key Parts

• Door latch failure
• Will not agitate

After watching the video it was strait forward. Just Pull the screws pop the lid swap the springs "grease them" and put it back together. I would suggest that you have a person help you mostly has a second pair of hands. The lid was over rear springs and it will save you some expletives to have the extra body. I had worn out springs and the load kept becoming unbalanced during spin cycles I just happened to coincide with the Lock mechanism failing. The motor drive for the lock stopped working.... Read more

• Door won't close

My dryer door would not stay shut because the door strike was stuck in the door catch. I was afraid that when I pulled the strike out, it would damage the catch, so I ordered the door strike and door catch. I got the damaged door strike out with needle nosed pliers in about 15 seconds. The door catch was in perfect condition so I didn't need to use the one I ordered. So then I proceeded to install the new door strike. That took me about 15 minutes because I did not have the manual strength to... Read more

Replaced door lock. It required removing the two screws around the lock, pulling the spring hoop wire from around the door gasket, and then disconnecting the two wire terminals from the lock. Reverse with the new part. After cracking open the old lock the failure was caused by a thin plastic tab breaking off. I also bought the door switch since it's cheap - just in case the problem was not the lock. But the door lock was the fix. Read more

I encountered a high pitched squeal and loud rumbling. I figured the sounds were likely the rollers despite not matching other sounds on the repair videos for other dryers. The repair video for dryer rollers on AppliancePartsPros.com is of little use until Minute 2:56 because this Electrolux 517 model uses mostly Phillips head screw to fasten the front and top panels in place. You may find one latch at the top front center that holds the top and front panels in place. After unplugging the... Read more

We have a corn-operation washer machine for my renter home that we took it over when we bough the property, When it broke we have no key. I order key as well as parts, and they come at no time. It is amazing, with the videos my husband was able to fix it, it save me a lot of money Read more

Replaced lid switch and lid magnet. Took just a little longer then 20 minutes as I had to splice in the new lid switch as it wasn't one that was a clip in, it was hard wired in. Read more

• Will not tumble

Replaced the tension pulley assembly, drum rollers, drum roller axles, belt, and drum glides while I had the dryer disassembled. It turned out that the cause of the squeak was the tension pulley assembly, however it was easy and economical enough to replace anything that could have been the cause of the squeaking while I had the dryer apart. The parts were ordered on Thursday afternoon and delivered on Friday. I had the dryer repaired and running like new in no time. For about $100, it was... Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

I ordered the male and female door latching parts. Read more

I followed the video on the parts page and had the part replaced in no time. My dryer door was slightly different than the example, but the concept was the same. My part arrived the next day and the repair took less than a half-hour. Extremely satisfied with this site Read more

We ordered a door switch, dryer latch and strike plate. We realized that we only needed to replace the door switch. We watched a few videos and then replaced the switch. We couldn’t find a video for our model but they did give us a pretty good idea about what we needed to do. The hardest part was getting the original door switch out, all of the videos we watched showed us that it would pop out with a little pressure from a flat head screw driver, from the front of the switch. We could not get... Read more

Went on line to Appliance Parts Pros Brought up the parts diagram located the new latch and prong for the drawer. My new parts arrived in 2 days installed the parts put the drawer assembly back together closed the drawer all all is fine. I have another pedestal drawer under the washer all the same age so I ordered a spare fully knowing I will need it sooner or later. Read more

Replaced the hinge receiver with a new one. The old one was bent slightly inside where it could not be seen. I think someone pushed the door down to far or fell on it. 2 screws to remove it, take out storage drawer and reach up little ways to remove and replace the receiver. Replace the 2 screws. The receiver comes with 2 screws but I ordered an extra ( never used it ). The sides of the receiver were spread just a tiny bit but were enough to cause a problem. Read more

I replaced it with a new latch/lock. Read more

My son-in -law replaced the entire lid and top along with the lid lock and safety lock on the lid. He has pictures of the process Read more