Bs26g0f1wh Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Too warm
• Clicking sound
• Won't start
• Freezer section too warm

I have a Kitchen Aid side by side refrigerator/freezer which is 8 years old. One day it just stopped cooling. At first I was just going to junk it and purchase a new one. However, I took off the lower back cover and noticed the compressor was not running. I knew from experience that these compressors need a starter capacitor and relay and it is not uncommon for these parts to fail. I looked on the Internet for a video which showed how to remove the parts. I also found a video which showed how... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

• Fridge runs too long
• Noisy
• Freezer section too warm
• Fridge too warm

After reviewing the 'how to' video on AppliancePartsPros.com, I unplugged the refrigerator and removed the back cover to access the motor. I then unplugged the wiring and removed the bad motor. I cut the clip plug and wired it to the new motor, installed the fan blade from the old motor and re-installed the new motor. After connecting the clip plug and re-installing the back cover, I plugged the refrigerator in and checked the interior about 5 minutes after the repair. Everything has been... Read more

• Door won't open or close
• Door sweating
• Frost buildup
• Leaking

I followed a video to remove the inside door panel and gasket. Putting the new gasket was as easy as the video said. The only problem was ice had built up on the inside of the door panel that needed to be defrosted. Read more

• Freezer not defrosting
• Frost buildup
• Fridge too warm
• Fridge runs too long

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

• Fridge too warm
• Doesn't shut off
• Noisy

The blower motor that circulates air through the refrigerator was broken. I had to remove all the shelving and drawers from the refrigerator. Then I had to remove the plastic light cover from the center of the fridge. Then I removed all visible screws to uncover the evaporator/radiator. I then unplugged the light bulb and motor wires. Luckily all wiring is keyed so that it can be plugged in again without error. I removed the motor by opening the motor housing. The housing has 1 screw and... Read more

• Freezer not defrosting
• Too warm
• Fridge runs too long
• Fridge too warm

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

I found freezer thermal link was open and not closing when cold. Replacement fixed problem. Read more

Ordered the two motors plus ordered the fan blades since I was afraid one might break during replacement. Changed out without breaking Freezer and both ice makers now working fine Read more

• Noisy

I bought new parts, motor and fan. Replace the old one. Took me no more than 15 minutes to fix it. Read more

• Fridge too warm

Unfortunately, this model has the screws that you need to loosen before you can squeeze the rubber in but the gaskets fit perfectly. It took a lot more time than the video showed but that was because the video was of the pop in type. Be sure when pushing the rubber under the metal strip you make sure it actually goes in. I think the last people installed the gaskets incorrectly and that's why they broke and pulled out of place. Unscrew the bolts first, I used an electric drill. The old gasket... Read more

One day my wife went to bake something and the bake/broil buttons as well as #3, #9, and oven light ceased to work. Local repair guy came by and wanted to charge $500 to fix it....YEAH RIGHT! Did a little homework and found this website, spoke with knowledgable staff who pointed me in the right direction. Took me all of about 20 minutes to install new control panel..everything works perfect...THANKS! p.s. In doing my research come to find Maytag did little to insulate control panel from oven... Read more

I replaced the control board and the microswitch. Read more

Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more