Kbrs22kgbloo Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

• Noisy
• Fridge too warm

The fridge is 20+ years old in a home we recently moved into. It sounded like a motor getting stuck on something or grinding weird... was hoping it wasn't something more serious. Found this site, clicked 'noisy' and got the replacement evaporator fan motor blade as well as the motor evaporator. Turned out I didn't really need to replace the fan blade, but since I had it and ours was old, figured I might as well put in the new parts. Followed the videos here, which were really helpful. The... Read more

• Too warm
• Clicking sound
• Won't start
• Freezer section too warm

Thank you to everyone who entered comments, especially about the "Clicking" sounds when it was trying to turn on the compressor. I did not notice them at first, but then heard them and was confident that one of these parts (or both) had a problem. In my case, I have custom cabinets around the sides of the refrigerator and hardwood floors in the kitchen so I put down some cardboard when the rollers would need to go at an angle due to a center island in the way. (I would rather do this myself... Read more

• Door won't open or close
• Door sweating
• Frost buildup
• Leaking

I followed a video to remove the inside door panel and gasket. Putting the new gasket was as easy as the video said. The only problem was ice had built up on the inside of the door panel that needed to be defrosted. Read more

Touch up paint Read more

Replaced It With New One Read more

• Freezer not defrosting
• Too warm
• Fridge runs too long
• Fridge too warm

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

• Freezer not defrosting
• Frost buildup
• Fridge too warm
• Fridge runs too long

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

I can't believe that we lived with this shelf bar continually falling off for years due to a broken end cap. Easily found the replacement end cap on AppliancePartsPros for our 18 year old refrigerator. The "repair", if you can call it that, took perhaps 30 seconds -- remove old broken end cap, insert new one. Done. No more shelf bar falling off. One of life's little annoyances just went away. Read more

• Fridge too warm

Unfortunately, this model has the screws that you need to loosen before you can squeeze the rubber in but the gaskets fit perfectly. It took a lot more time than the video showed but that was because the video was of the pop in type. Be sure when pushing the rubber under the metal strip you make sure it actually goes in. I think the last people installed the gaskets incorrectly and that's why they broke and pulled out of place. Unscrew the bolts first, I used an electric drill. The old gasket... Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more

• Freezer section too warm

I ordered the replacement gasket and...replaced it. One issue was that the replacement procedure was not at all like the video to which I was directed when I got the gasket. The video showed a gasket with a rigid flange that had to be inserted into the door structure. On my Amana, I clearly had to remove the inner plastic liner and set the gasket under it. This was not particularly difficult but certainly wasn't the same process. Also, I removed the freezer door to do the replacement in... Read more

• Noisy

Refrigerator was not cooling, but was continuously runing & freezer compartment was extremely cold. Determined that fan assembly that takes freezer air & circulates to the refrigerator didn't seem to be working. Determined that the fan assembly motor was not rotating. Easily found replacement on AppliancePartsPro.com. Received the part quickly (Impressive delivery time!). Unplugged refrigerator, then easily removed to rear cover inside the freezer section by removing hex head screws.... Read more

• Freezer section too warm
• Won't start

After running some tests I determined that the problem was a bad defrost timer. The timer would occasionally fail to trigger the compressor to restart at the end of the defrost cycle. Since I had the unit taken apart, I replaced the termination t-stat and the compressor start relay at the same time. Parts came quick 1.5 days, job completed and the unit is up and running. Read more

We found the right ice cub bin/pan, ordered it, and it arrived quickly. Fit perfectly, and it is now catching our ice. Read more