Shv99a15uc Parts

We replaced the black door seal gasket around the front of the dishwasher. The old black seal gasket had begun to deteriorate, every time it was touched black stuff would rub off onto hands and onto utensils in the upper basket. We wore some disposable gloves to remove the old seal to avoid getting the black stuff on our hands. Before entirely removing the old seal gasket we studied its placement to tell which way the new seal gasket should be placed. We didn’t want to place the seal gasket... Read more

I bought the door and bottom seal and was already to go. Appliance Pro got the parts to me in 2 days. I read an article that said if the spray arm holes are blocked that this could cause a wave in the dishwasher that could cause the water to fly up to the inlet used for drying and the water could run down between the front and inside door appearing to be a leak. I checked and my spray arms were indeed blocked. I pulled them out, cleaned them up, reinstalled, and low and behold that was appeared... Read more

I changed the control board (00498022) in the door of my Thermador dishwasher. Thermador, Bosch, and Siemens all use the same board for the indoor controls and display. This required a #15-star head driver to remove the screws. I used an impact wrench (set to a low torq setting) to speed things up. There are approximately 12 screws to remove. Two are long. The rest are short. Be careful to hold the door together as the last screws are removed. Everything comes apart easily and you do not... Read more

• overflowing
• Noisy

Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more

Purchased a new rack and would have skipped reporting on it except that the new rack is superior to the old one. Easy to load, better silverware basket. It is so much better I bought a one for my mother (same dishwasher - lucky her!) before she even had a problem with the original. Read more

Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more

• Won't start

Replaced with new latch, took about 5 minutes. T25 torx screwdriver and flathead screwdriver needed. Read more

• Leaking

Ordered replacement drain hose, left hand panel of dishwasher removed (remove 2 screws in front left trim panel & friction fit clip at top back then slide up & off. This reveals the O-ring drain hose connection point. You need to remove the retainer block where the hose exits the appliance. Old hose pulls out and new hose pushes in. In the end a very easy installation. Most of the time spoent here is removal & reinstallation of dishwasher back into position - the actual hose swap takes 10 mins Read more

Checked out the AppliancePartsPros.com online parts/assembly diagrams for our Bosch dishwasher model and ordered the two sided set of new springs + connector ropes + connector-to-door ... plus a couple of other relatively inexpensive adjoining parts that might have become worn over time, just in case they were needed. The extra parts arrived in two days with standard shipping. Called about the "back ordered" primary set of parts (which had been listed as being "in stock" when I placed the... Read more

On my Bosch she55m15uc/64, the cycle would take 3-4 hours, with the machine stuck on "1 minute" for a long time. The interior was getting moldy and smelly, and the dishes had a white film. At first, I thought it was the heater relay on the control board, but I pulled that relay and it seemed to be working. I could get an ohmmeter on the heater element without taking the bottom off the dishwasher, and the resistance was infinite. Replacing the heater did the trick. On my unit there was a... Read more

Repair estimate was $250 parts, $250 labor to change out the circulating pump. I decided to do it myself. Pump was $166 from AppliancePartsPros. It arrived in 4 days. I looked at the video on their website, followed the instructions step by step and did it myself. They estimated 45 minutes. It took 2 hours.There are always minor differences so always take photos of yours. Suggest that you bag up all screws and pieces from each part as you take them off and label the bag. I had 12 bags with 2 to... Read more

Ordered replacement parts from AP diagram Read more

• overflowing
• Will not fill with water

I checked continuity at the float switch since I knew the inlet valve was working when direct wired to 120v. Switch did not have continuity. Replaced switch and inlet valve worked at start of cycle. Read more

Somehow one of the mounting brackets disappeared after I had the cabinets and counter replaced, but these were a perfect replacement. They don't stick out as wide as the original brackets, but I think these are a better design. Also, the I found the original brackets online, but they were way overpriced, so i was glad to find these. Read more

Easily installed the side mounts and put new trim around the opening. Read more