Need Help?
Call or text
Show parts
Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.
Usually ships within 4 - 14 days
This PM sheet mini manual is a printed service document that provides short preventive-maintenance guidance and basic service notes for use during appliance inspection or routine maintenance. Keeps key maintenance steps handy. What it does:
Size: 8-32 x 5/8 inch.
This part is discontinued by the manufacturer and is no longer available for purchase.
Replacement mounting screw for securing panels, brackets, and components inside your appliance. Needed when original screws are stripped or missing.
Size: 10-16 ab.
The Interlock Switch is an OEM replacement part for GE electric and gas dryers. This safety component monitors the door closure, preventing operation if the door is not securely closed and latched. The switch measures 2 inches long and 1/2 inch wi
Metal contact leaf for dishwasher switch assemblies. Replace if the original contact is bent, corroded, worn, or missing to restore proper circuit closure.
Protective heat shield that installs inside your dishwasher to guard internal wiring and components from heat and debris. Replace if cracked or missing.
Size: 8-18 x 7/8 inch.
Fixes spotty dishes and rinse aid leaks. This reservoir holds and releases rinse agent during the final cycle. Quick DIY repair with video guide.
Replacement door vent directs humid air out during the dry cycle. Install inside the door panel to replace a cracked, clogged, or missing vent.
Cushions and seals the dishwasher door vent to route steam safely while protecting the control area. Replace if worn, moldy, or causing leaks.
Dispenser won't close or stay shut? This dishwasher detergent cup cover securely latches to prevent mid-cycle opening. Moderate DIY repair, 1 hour.
Dishwasher detergent cup won't stay closed or won't open fully? This soap dispenser lever controls detergent release. DIY repair in 15 minutes.
Size: 10-12 x 1/2 inch.
Detergent cup won't stay closed? This dispenser latch secures the detergent cup during wash cycles. Direct replacement part with video guide available.
The Fill Cap Assembly is an OEM part for GE dishwashers. This assembly includes the cap that covers the opening where rinse aid or other additives are poured into the dishwasher. It ensures that the additives are securely contained and properly dispens
Replacement spring for dishwasher detergent cup door assembly. Provides tension to keep cup door latched closed. Replace if broken, stretched, or lost.
The Door Gasket is an OEM part for GE dishwashers. It forms a seal between the dishwasher door and tub which is critical for proper operation. The gasket ensures excess water and moisture do not leak from the dishwasher during active wash and rinse cyc
Detergent cup not opening during wash cycle? This actuator lever connects the timer to the dispenser lid. Moderate DIY repair, about 35 minutes.
Trim piece that surrounds and protects the timer on your dishwasher control panel. Replace if your original cover is cracked, faded, or missing.
This replacement timer is a genuine OEM part for a dishwasher. The timer works to regulate a dishwasher's cycles by controlling how long power is supplied to the internal components. This allows the dishwasher to have multiple wash modes and shut on or off automatically once set by the operator. The timer assembly can be located behind the kickplate in the door or at the top of the control panel. Dishwasher timers are often misdiagnosed as the problem in a faulty appliance, so be sure to test the timer before immediately replacing it. Using a multimeter, test the timer for a range of roughly 2,000 to 3,500 ohms. If the part does not give a reading within this range, it should be replaced. Disconnect the two attached wires and mark them so that they can be properly reattached during reassembly. Needle-nosed pliers are recommended for this job, as they can provide a more delicate touch than just yanking out the wires. This replacement timer is compatible with Kohler washers and comes sourced from its original manufacturer. This part does not include any additional hardware so be sure not to lose any of the screws removed during disassembly.
Color: Black.
Includes 12 terminals.
Includes 12 screws.
Secures control knobs to the dishwasher control shaft. Replace this latch if your knob is loose, wobbling, or won't stay engaged on the shaft properly.