White Westinghouse Washer Parts

Front tub shell for your washer. Replacement needed when the outer tub is cracked, broken, or has pieces breaking off during operation.

Secures and seals your washer's drain hose connection to prevent leaks. Replace if cracked, brittle, or leaking. Confirm fit with your model number.

Positions the transmission bearing block for proper alignment in your washer. Replace if worn, damaged, or missing to restore correct drivetrain spacing.

Carriage bolt for washer assemblies. Secures structural components and mounting hardware. Replace if missing, stripped, or corroded during repairs.

Replacement bolt fastener for securing washer panels, brackets, and assemblies. Needed when original bolt is missing, loose, or stripped causing rattling.

This dispenser valve assembly controls water flow to the fridge door dispenser for reliable dispensing and shutoff. It replaces a failed valve to restore proper water delivery and stop unwanted dripping or leaks. What it does

• Opens and closes the water passage when the dispenser actuator is pressed to deliver water to the glass.
• Seals the water line to prevent drips or continuous flow when the dispenser is idle.
• Helps stop intermittent dispensing or no-water issues caused by a faulty valve.
• Works with the door dispenser plumbing—electrical/connectors remain unchanged.

• Disconnect power and shut off the refrigerator water supply before starting.
• Remove the refrigerator door panel or access cover per your model's service instructions to reach the valve.
• Verify electrical connector seating and water line fittings are secure; replace any damaged tubing or seals.
• Test for leaks and proper dispensing after restoring power and water.

White timer control knob for washer control panel. Replaces cracked, broken, or missing knobs that make cycle selection difficult or impossible.

Mounting screw for laundry center panels and components. Replace missing, stripped, or damaged screws to secure parts properly during assembly or repair.

Secures interior trim and components in your laundry center to prevent rattling and shifting. Replace when worn or broken to restore a snug fit. Verify compatibility with your model number.

Replaces a cracked, broken, or missing baffle (vane) inside your washer drum. Installs from outside the basket with a single screw. Helps move clothes.

This is the front half of the outer tub that encloses the wash drum and holds water during the wash and rinse cycles. It forms a watertight seal with the rear tub half and includes the opening where the door boot seal attaches. Replace this assembly if the tub is cracked, leaking water onto the floor, or if the drum bearing seat is worn out and causing excessive noise during the spin cycle.

Support plate for washer components. Mounts internally to secure parts in place. Replace if cracked, bent, or broken to restore proper structural support.

Wiring harness for laundry center washer. Connects electrical components throughout the machine. Replace if wires are frayed, connectors are damaged, or broken.

Mounting screw for washer cabinet and component assembly. Replace if screw is stripped, missing, or damaged during disassembly. Essential hardware piece.