Need Help?
Call or text
Replaces worn dryer front bearing and seal that cause squealing or scraping noise. Essential for smooth drum rotation. Confirm fit with your model.
After having replaced the drum support rollers twice in a roughly 3yr period, I realized something wasn't quite right, and indeed it wasn't. I had been ordering the wrong parts - I did use the online parts locator after checking, & double checking my model number. Apparently my older Whirlpool dryer has a somewhat ambiguous model number because the rollers that were shipped each time looked nothing like the originals. I realize that is not particularily uncommon - manufacturers often modify... Read more
Prevents water and air leaks at the dryer front panel. Replace if worn, cracked, or causing moisture issues. Verify fit with your model number.
First I watched videos about squeaking Kenmore dryers. Then I used that information to open the dryer, diagnosing the fact that the roller on the drum belt tension arm had broken and actually fallen off the arm. The dryer was filled with lint and dust/dirt, so I also saw that the seals on the dryer had deteriorated greatly. AppliancePartsPros website is outstanding, far better than its competitors. This made it easy to find the parts and videos that I needed. It took hours to pull everything... Read more
Replace your dryer door seal to prevent heat and moisture from escaping around the door edge. Installs by pulling off the old seal and pressing the new one into the door slots. Verify fit by model number.
Put new seal on. Read more
Dryer door seal prevents air leaks and retains heat inside the drum. Replace when loose, torn, or causing heat loss. Includes adhesive. Verify fit.
Ordered new seal and the correct adhesive to use and followed directions for resealing of the door. Read more
Seals the gap between drum and bulkhead to maintain airflow and quiet operation. Replace when worn to eliminate squealing, reduce lint buildup, and prevent fabric snags. Confirm fit by model number.
I took it apart and cleaned and lubricated the rear support rollers and the belt pulley roller. I think the squealing was coming from the pulley roller. I then replaced the rear felt as it was badly deteriorated. The dryer now runs much more smoothly and quietly. Read more
Seals the joint between the lint screen housing and blower assembly. Replace when worn to prevent lint buildup in cabinet. Confirm fit by model number.
Watched You tube videos to narrow the problem down to old deteriorated gaskets. Read more
Seals the light lens to the oven cavity, blocking heat, steam, and grease from the bulb housing. Replace if cracked, brittle, or missing. Confirm fit.
Troubleshot the oven by checking the broiler which worked good (same fuel valve). After reading the some tips about troubleshooting the Glow Ignitor I could see the broiler ignitor got white hot and the oven ignitor only got bright orange (orange to red causes intermittent ignition or mini explosions). Watched the how to video and it was good information. You should be observant about which openings in the back of the oven as to where the two wires are coming out of. My oven is over 12 years... Read more
Replace your worn dryer door seal to restore a tight closure, contain heat and moisture, and eliminate rattling or squeaking. Easy snap-in install.
Repair was very easy. No instructions included but basically start the new seal tabs at the bottom in the middle and work your way around snapping in place. 60 seconds Read more
Seals the glass panel in your dryer door to prevent air leaks and maintain drying efficiency. Replace if damaged, melted, or loose. Verify fit by model.
Seals the dryer door perimeter to contain heat and prevent air leaks. Replace if damaged, stretched, or pulled off during cycles. Confirm fit with your model.
Ordered a new gasket, easily installed by popping into slots, took only a minute to install, had dryer three years and never happened before, suspect sheet caught in door when started and pulled gasket off. Thought about gluing gasket , decided to just be diligent about inserting clothes etc. Read more
Fiberglass-reinforced door seal that restores airtight closure to maintain consistent temps and reduce energy waste. Replace if torn or compressed.
Vinyl door seal lines the dryer door perimeter to block air leaks and cushion closure. Replace when worn or cracked to restore a tight seal. Verify fit by model.
Ordered new gasket and adhesive! Read more
Dryer drum felt seal creates an airtight barrier between drum and cabinet. Replace if worn, torn, or clothes show lint buildup. Verify fit with model.
Replaces worn or stretched dryer door seals that allow heat to escape. Maintains proper drying temperature. Verify fit with your model number.
Replaced it with a new seal Read more
Dryer drum seal prevents air leaks and maintains proper airflow. Replace if you notice loud squeaking, excessive lint, or reduced drying efficiency. Confirm fit with your dryer model number before ordering.
Heat-resistant fiberglass gasket seals your oven door perimeter to maintain consistent temperatures. Replace when worn, frayed, or flattened to restore efficiency. Verify fit by model number.
Usually ships within 4 - 14 days