Whirlpool Hose Or Tube

This flexible replacement hose routes water inside the appliance to restore proper water flow and prevent leaks. Built to match the original shape and connections for a direct-fit repair when the original hose is damaged. What it does:

• Transfers water between internal components to enable normal operation
• Prevents leaks caused by cracks, splits or worn material
• Helps stop intermittent or reduced water flow when the original hose is compromised
• Restores secure connections at existing fittings when installed correctly

• One replacement hose

• Disconnect power and shut off the water supply before starting the repair
• Inspect matching fittings and clamps; reuse only compatible hardware or replace as needed
• Seat hose fully on fittings and secure with appropriate clamps to prevent leaks
• After installation, restore power/water and run a short cycle while checking for leaks

The Manifold is an OEM part for Whirlpool dishwashers. It is located inside the dishwasher and is responsible for delivering water from the inlet valve to key areas during different wash cycles. With drilled port holes machined into durable plastic, the manifold efficiently circulates water where needed.

Causes of a bad manifold can include mineral or sediment build up in the water ports over time, cracking or other physical damage.

Symptoms of a bad Manifold include:

• Water leaks or drips from internal connection points
• Uneven spray patterns from spray arms
• Low or no water pressure during fills
• Incomplete cleaning even on high wash settings

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This replacement drain hose routes wastewater away from the appliance to the household drain so your unit can empty reliably and avoid standing water. Designed to match the original fit and flow path for easy replacement. What it does:

• Carries waste water from the appliance to the home drain or pump outlet
• Helps prevent water backup, pooling, or slow draining when functioning correctly
• Replaces cracked, split, or deteriorated hose that can cause leaks
• Restores the intended water flow path to reduce the risk of overflow or damage

• Disconnect power and shut off water supply before beginning any repair
• Remove and replace the old hose, using existing clamps or new clamps rated for appliance use
• Route the hose to match the original path; avoid kinks or tight bends that restrict flow
• After installation, restore power/water and run a short cycle to check for leaks

This replacement fill hose routes incoming water from the inlet valve to the washer tub so the machine fills properly. It restores proper water delivery and helps stop leaks caused by cracked or damaged hoses. What it does:

• Carries water from the inlet valve to the wash tub during fill cycles
• Prevents leaks and water loss when intact and securely clamped
• Can cause slow or no-fill symptoms if kinked, split, or detached
• Works with the washer's existing inlet valve and hose clamps

• One fill hose

• Turn off power and shut off the water supply before installing
• Inspect and reuse or replace hose clamps and any sealing gaskets as needed
• Route the hose without kinks and secure to the inlet valve/tub connections
• Check for leaks after restoring water and power