Whirlpool Refrigerator Parts

Well, I took it out (it slides out) to get a good look at it,so i could ref pictures on your site..naturally I had serial/model of refrig,and thats mandatory to get the right part. It came in 2 days,,and being just the bucket, it took only a few minutes to transfer the auger assembly/cube/crusher.... into the new one, 6 screws total..Your site has excellent vids on DIY.......I HIGHLY reccomend. Whole process was'nt over 15 minutes, piece of cake....And NOW i can go back to my nightly 'scotch... Read more

Replaced entire ice maker. A couple of important points. (1) The ice maker module does not include all parts. The door flap for example is not included. So save all plastic parts from the old unit including screws. The biggest installation problem was the power cable. There was little room on the side of the ice maker for the cable and connectors to fit. Make sure the connector that mates with the refrigerator cable is seated onto the plastic housing and does not stick out or dangle out.... Read more

Installed it according to video watched. Read more

There is nothing you can't do given the right YouTube video! We disassembled the bottom mount freezer n our Jenn Air refrigerator to remove all the ice and then located the clogged grommet on the back of the unit and cleared it and added a notch. In the process of reassembling we broke the bracket on a part that should have been the easiest portion of the entire installation! In seconds we located and ordered the part on your site. It arrived in a couple of days and then we removed the door and... Read more

New shelf. Read more

Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more

Part easily replaced and problem was solved. Saved service call. Read more

Replaced housing. That was simple but finding directions in how it I remove top of cabinet was time consuming. After two hours of searching I finally found one article that explained why there were no screws to remove. Read more

Let you know when it gets installed Read more

Ordered replacement part Read more

The refrigerator was given to me and hasn't defrosted since it was new. I found the defrost timer had a burnt spot on the circuit board. After installing a new timer, the refrigerator would trip the circuit breaker in my house when it entered defrost mode. I found that the pink wire running from the control board all the way to the thermostat was shorted somewhere between the two parts, inside the refrigerator. I ran a new "pink" wire and all is good. Read more

Removed & replaced baffle. Make sure you have a 1/4" nut driver. You can't see the nut that is at a 90 degree angle from the front of the refrigerator. There is a second nut hidden behind the air filter at the back of the compartment as well. Once you remove these two, the plastic housing comes off & the assembly (which is mostly made of Styrofoam) is easily replaced. Read more

I ordered a complete new bin with everything in it attached already. All I had to do was wash it and set it in the compartment on freezer door. Within a couple hours, I had ice again. Easy fix. Read more

Replacement of parts found on this site- great explanation and pictures as shown! Read more

Ordered new crisper, cover, and new crispers Read more