Whirlpool Refrigerator Parts

Simple Repair. Read more

My fridge was too cold - everything was freezing solid, even in the produce bins. The air from the diffuser vent was constantly running. After unplugging the fridge and plugging it back in, the diagnostic code on the control panel indicated that the air diffuser was not working. I purchased a new air diffuser, watched the very helpful video that showed how to install it, and replaced the part in about 10 minutes. The next day, I can tell that everything in my fridge has finally begun to thaw... Read more

Replacement of parts found on this site- great explanation and pictures as shown! Read more

Replaced door seal as per video from your resources. went very well no problems Read more

Replaced light switch. That did not work, problem was in led lights. Read more

It's bit of a chore in that on my Whirlpool Refrig you need to remove the grill on bottom front and the Utility Panel on bottom rear. Then unscrew the original filter housing and pull it out through the back of utility opening. Remove the two water hoses and put them into new filter house. Reverse the disassembly process to reinstall new filter housing. I'm old and slow so the process took me about 45 minutes. (Note: Unplug electric and turn off water inlet before starting.) Read more

• Won't start
• Fridge too warm

Took access panel off the back of the refrigerator with 1/4 inch nut driver and found that the compressor was not running properly (humming and hot but not compressing). The compressor cooling fan was working as well as the fan in the freezer compartment. I fixed the same problem with another refrigerator by replacing the relay and start capacitor on the compressor. I pulled these two items from the compressor connector (gently pry the brown part from the comp terminals first and then the... Read more

Once the parts arrived, I followed the help video that was emailed to me with my order confirmation step by step. Super useful! The video quality and editing were well done and the instructions were very specific. I felt like a pro! Read more

I replaced the gasket Read more

1. Purchased a new Facade. The removal of the old one was relatively easy except that the two screws that hold it in place (behind the spill tray) were rusted (they should have used stainless steel ones) one came out with a vise grip but on the other I had to buy an "Easy Out" tool from Home Depot, once out the unit drops down. Had my wife hold the new unit, swiped the wires from old to new, removed the control board from the old one and installed it on the new one with one screw and cleaned... Read more

Replaced with new one. 45 years experience in appliance repair. Read more

I replaced the freezer door seal. Read more

• Ice maker not making ice
• Leaking

Order new valve Read more