Whirlpool Wall Oven Parts

I first diagnosed the problem by replacing the burner control (Infinite switch) with one from a smaller burner (one that I knew worked fine). That seemed to solve the problem. I ordered the correct control for the big burner on Saturday night, it arrived Tuesday and installed it in less than 10 minutes using only a Phillips screwdriver. Remember to unplug the stove before performing any service. Take this time to clean around and under the stove. (You know it needs it!) Read more

Ordered new seal pulled old one off and put new one in its place Read more

Replaced the burner. Read more

Follow step by step as show on YouTube how to replacing burner elements before you work. It easy with less than 15 minutes. Save $$$ on labor cost Read more

• Element will not heat

Personally I have experience working with electricity and knowing if I bought the part required this would be an easy fix. I got my model number and contacted Appliance Parts Pros and placed my order for the new elements, terminal blocks, and for appearance purposes 4 new Drip Pans. Excellent service and quick shipping. I ordered my parts on Sunday and received them on Tuesday. This was a simple repair that only required a screwdriver to remove the old terminal block from the range hood, wire... Read more

Ordered a new knob, and put it on. Read more

• Little to no heat when broiling

Ordered a new part. Watched a YouTube video. Fixed it in 15 minutes. Knowing you need to stop the connectors from slipping into the back of the oven was the key. I used paperclips to stop the wires falling through the hole. Easy as ... Read more

Ordered the part, which was easy and smooth. Watched you tube video on how to repair. Took me 15 minutes. Easy as it could be. Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

After researching the problem, I ordered a new cooling fan. My "fix-it" guy winds up in the ICU for 3 weeks! So...YouTube here I come. It appeared pretty simple in video form, except the video wasn't of my stove. All in all, what looked like no more than a 6 screw removal, turned into tearing 1/2 the stove apart. Still, only took about 2 hours start to finish. Best lesson learned, turn off the energy efficiency mode!!! Read more

Replaced the blown heating element. I also only to be on the safe side, replaced the over temp sensor. I checked it with the meter when I pulled it out and it was ok. Tested ok. Thank you very much for the less than 2 day delivery on the part. Read more

The first thing I did was I went online to appliancepartspros.com . I then did a search for the model of stove I had and obtained a parts list. Found the part I needed and ordered it. Now the best part is I got what I asked for!!! The correct replacement knob with the correct finish. I replaced the knob and my wife was happy!!! Thank you appliancepartspros.com. Read more

• Element will not heat

1. Went online where I watched video about heat control for this Maytag. I then found AppliancePartsPros using Google. I ordered the part and In three days the part arrived. I installed the part and now the problem has been corrected. Read more

I determined the hidden bake element below the oven cavity was not working, because the bottom of the oven was cold during normal use. If you have a built-in microwave + oven combination (mine is KitchenAid Model No. KEMS308SSS05), this is a difficult repair. The engineer who designed this oven should be invited to succeed elsewhere. It is impossible to access the bake element from the inside of the oven, so the How To video associated with this part will not help you. I had to remove the... Read more

Ordered part, went on line and watched video on how to make the repair. Read more

• Little to no heat when broiling

The upper element in the top oven burned out. This was likely due to sugary food that had gotten on the element when the food was moved in/out of the element. The element was coated in crusty, burned food and the element was cracked in six or so places. The oven is a Maytag Gemini double oven range. The model number appears to be MER6875AAQ based on our receipt and manual. We did not pull out the oven since it is difficult to do so in our kitchen. Taking out the old element only... Read more