Amana Gasket & Seal

This evaporator cove seal is the replacement gasket that helps keep the evaporator compartment sealed for efficient cooling and proper defrost drainage. It restores the evaporator cove barrier to help maintain temperature consistency. What it does:

• Seals the evaporator cove to limit air exchange between the evaporator area and the fresh food/freezer compartments
• Helps direct defrost water to the drain path and reduce water pooling inside the appliance
• Reduces frost buildup and cold-air loss around the evaporator area
• Commonly replaced when you see frost/ice buildup, interior water leaks, or uneven cooling

• Disconnect power before starting any repair to avoid shock or injury
• Remove shelves/food and allow the appliance to defrost if ice is present before replacing the seal
• Inspect the evaporator cover and mating surfaces; clean and dry surfaces for a proper seal
• Seat the seal evenly around the cove; avoid overstretching or sharp tools that could damage the gasket

This evaporator cover seal is a foam gasket that seals the evaporator cover to help maintain proper airflow and temperature control inside the freezer compartment. It reduces frost buildup and helps the appliance run efficiently. What it does:

• Seals the evaporator cover to prevent warm, moist air from reaching the evaporator
• Helps reduce frost and ice buildup on the evaporator coil
• Supports consistent freezer temperatures and more stable cooling performance
• Can help prevent excessive run times and reduce strain on the compressor

• One evaporator cover seal

• Designed to fit the evaporator cover area; follow your model's service manual for exact placement
• Requires removal of interior panels or the evaporator cover to access the sealing surface
• Clean mating surfaces of old adhesive/residue before installing for best adhesion and sealing
• Disconnect power to the appliance before servicing to avoid electrical or injury hazards

This O-ring creates a watertight seal in your dishwasher's wash or drain system, helping prevent leaks and maintain proper water pressure. Replace a brittle, flattened, or damaged ring to restore a reliable, leak-free connection.

• Provides a watertight seal between mating parts such as pump housings, fittings, or hose joints
• Helps stop drips and seepage caused by a worn or deformed seal
• Common symptoms: water under the unit, moisture around pump/tubing connections, or leaks after reassembly
• Replace if the old ring is cracked, cut, flattened, or hardened

• Disconnect power and turn off the water supply before servicing
• Place a towel or shallow pan to catch residual water
• Clean the groove and mating surfaces; lightly moisten or use a manufacturer-approved lubricant to help the ring seat without pinching
• Seat evenly, reassemble without overtightening, and run a short test cycle to check for leaks