Amana Refrigerator Parts

Replaced the kick plate (grille-toe) Read more

Replaced stopper. Read more

Required new ice bin (container) which has busted up in pieces from the stress of trying to turn while half melted ice had it jammed, something had to give. Ice auger ripped itself out of the dispenser end breaking the ice container. Got new container, disassembled per the drawing, reassembled. Read more

Appliances came with the house we recently purchased, but there were a few parts on the Jenn Aire refrigerator. It looked terrible! It was super-easy to locate the pieces I needed, but honestly I was not confident they would fit. But they did, and perfectly! My refrigerator looks brand new. If I ever need parts or to make a repair, this will be the first place I will turn. Thank you! Read more

Did some research via the internet and figured the problem was likely the moisture control board. Watched a video of the repair of a similar unit in order to locate the moisture control board. Used the chat feature with one of the Appliance Parts Pros to get a schematic of the dryer and advice about where to use the putty knife to release the springs for access to the board. Thanks to the lady I chatted with for expert advice. Once the actual task was started, the repair took 15 or 20... Read more

Replaced the motor, however not the easiest to do with the older refrigerators. First I had to remove the shelf that hold the ice bin. There is a small screw midway underneath the tray. Once removed the shelf is loose but still hard to remove. There is a side panel that is slotted andonce removed the shelf can then be removed, but not knowing that it is a very odd fitting unit. Then comes the unplugging which cannot be seen so it is all by feel. Once the shelf drops down the plug is now... Read more

I unplugged the refrigerator and took the fan and motor out and replaced it, it was easy. Read more

Replace ice deflector. Read more

I removed the shelves and the shelf holders, took the back panel off, loosened the evaporator. Removed the heater element and the thermostat. Re-installed the evaporator the back panel, shelve holders and shelves. Then I located the defrost timer in the refrigerator. Read more

Replaced the ice tray and motor mount plate. While I was there I replaced the thermostat also. New parts arrived in a day and a half. Read more

Bought the parts and connected same...a breeze in finding and receiving and eventually installing these parts. Read more

Remove unit, remove about 12 screw holding the top to the unit switch the tops reverse steps and done Read more