Bosch Parts

Replacement silverware basket with handle for dishwasher lower rack. Holds utensils upright for better cleaning. Replaces cracked, broken, or missing baskets.

Circular sealing gasket creating watertight joints between dishwasher components. Replace when flattened or cracked to prevent leaks. Confirm fit by model.

Restores proper door balance on your dishwasher. Replaces a worn, broken, or missing door hinge spring that causes sagging or doors that won't stay open.

This includes one single foot. For the four pack order part number 00413552

The Burner Cap Assembly "C" Matte Blk is an OEM part for Bosch gas cooktops. As the rounded covering fitted over individual burners, it safely contains flames underneath cookware. Maintaining proper cap placement is vital for heating performance and safety compliance standards.

Causes of a bad burner cap assembly can include cracks or punctures from sustained high temperature cycling that compromise its insulating barrier. Over time, surface imperfections like scratches also diminish durability against consistent heat exposure.

Symptoms of faulty caps are:

• Flames improperly escaping from under pan edges
• Visible damage present on cap surfaces
• Inconsistent flame height adjustment or shut-off
• Excessive heat concentration in burnered area

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Traps food debris and particles in your dishwasher sump. Replace when clogged with hard water deposits or buildup affects cleaning. Verify fit by model.

Removes chlorine and impurities for better-tasting coffee. Replace after approximately 400 cups of coffee or 1000 espresso shots. Verify fit with your model.

Seals the NTC temperature sensor port in your dishwasher to prevent leaks and ensure accurate temperature readings. Replace if leaking or worn. Verify fit with your model number before ordering.

Fix a washer that won't stop filling or overflows during cycles. This water valve magnet controls water flow during wash and rinse. Common DIY repair.

Fixes ice maker overflow and water leaking into freezer. This water inlet valve controls water flow to your dispenser and ice maker. DIY repair.

Flexible rubber seal between washer tub and door opening. Replace if you notice leaks, tears, mold, or water dripping during cycles. Confirm fit with model.

Dishwasher not filling with water or soap not dissolving? The water inlet valve controls water flow into your dishwasher. Takes about 1 hour to replace.

Support strap that cushions and secures the dishwasher circulation motor, stabilizing the motor assembly to reduce vibration and help maintain alignment for steadier, quieter operation. Designed for circulation motors with softer bearings. What it does:

• Cushions and supports the circulation motor to limit movement and vibration and reduce motor noise.
• Secures the motor assembly to the tub/chassis to maintain proper clearance and fit.
• Helps prevent undue stress on motor bearings and mounting points that can cause premature wear.
• Commonly replaced when the strap is cracked, stretched, or no longer holds the motor firmly in place.

• Disconnect power and water supply before servicing; follow all safety and OEM service instructions.
• Remove access panels and any obstructing components to reach the circulation motor as required.
• Replace using the original mounting hardware; inspect motor mounts and bearings while accessible.
• Reassemble and run a short test cycle to confirm reduced vibration/noise and proper motor operation.

This is an electronic lock mechanism designed for the coin box on commercial-style washing machines. It secures the coin collection compartment to prevent unauthorized access. Replace this lock if the coin box no longer latches properly, the lock mechanism has failed electrically, or the key no longer engages the lock.

Fix a microwave door that won't pop open when you press the button. This door release lever restores smooth latching action for easy everyday use.

Replacement foot assembly for gas cooktop or range grates. Installs on the underside to cushion contact and stabilize the grate. Replace when worn, missing, or broken.