Bosch Parts

Approximate dimensions: 16.5" x 11.5" x 0.25"

This oscillating system (C) is the replacement assembly that provides the controlled back-and-forth motion used by a driven component in compatible Bosch appliances, restoring proper movement and operation. What it does

• Transmits oscillating motion to a linked component to enable normal operation.
• Restores movement when the driven component is stuck, doesn't oscillate, or moves intermittently.
• Can reduce abnormal noise caused by a worn or damaged oscillating mechanism.
• Helps return consistent, even operation when oscillation is required for performance.

• One oscillating system (C) assembly.

• Disconnect power to the appliance before beginning any service.
• Access may require removing exterior panels or components; keep fasteners and small parts organized.
• Inspect surrounding parts (mounts, linkages) for wear and replace if damaged.

This spin speed knob lets you select wash spin settings so you can adjust water extraction for different loads. It replaces a worn, cracked, or loose dial to restore clear speed selection and smooth control. What it does:

• Selects the washer's spin speed setting for proper water extraction
• Restores firm, accurate dial operation when original knob is loose or broken
• Helps prevent accidental speed changes during a cycle
• Matches OEM fit and detent locations for correct alignment

• Remove power from the appliance before attempting replacement
• Typically pulls off the control shaft; inspect for retaining clip or set screw
• If knob does not seat fully, verify shaft and index tab are undamaged

Bosch coffeemaker filter

This is a replacement electrical cable harness used to restore power or signal connections inside compatible appliances. It provides a direct, OEM-style connection for reliable operation and safer performance than damaged wiring. What it does:

• Replaces damaged or frayed wiring that can cause loss of power, intermittent operation, or control failures
• Restores proper electrical connections between components to prevent shorts or erratic behavior
• Helps eliminate issues like unresponsive controls, motors that won't run, or intermittent cycle problems
• Matches the OEM routing and connector style for correct fit and reliable contact

• Disconnect power before starting any repair to avoid shock or injury
• Inspect connectors and routing; replace any retainers or clips that are damaged
• Ensure connectors are fully seated and wires are routed away from moving parts and heat sources