Parts for Speed Queen STGNCASP115TW01: Control Panel / Cabinet Wrapper-10 Degree Front Coin Models Parts

This silver momentary rocker switch replaces a worn or broken control switch to restore reliable on/off or cycle-control operation. It provides a direct replacement for faulty user-interface switches on compatible laundry equipment. What it does:

• Acts as a momentary on/off or cycle-control switch for user input functions.
• Replaces cracked, stuck, or non-responsive rocker switches to restore control responsiveness.
• Stops intermittent electrical contact that can cause no-start or inconsistent cycle behavior.
• Fits into the control panel and mates with the appliance's existing switch connector.

• Disconnect power to the appliance before starting any repair to avoid shock or injury.
• Access typically requires removing the control panel or console; keep hardware organized for reassembly.
• Remove and transfer any retaining clips or connector housings carefully to avoid damage.
• Test switch operation after reconnection before fully reassembling the console.

This push button switch mounts in the appliance's control panel and sends an electrical signal to the control when pressed. Replace a worn or sticking switch to restore dependable button response and function activation. What it does:

• Panel-mounted switch that closes its contacts when pressed to signal the control
• Restores reliable front-panel input for starting or selecting a function
• Helps address no response or intermittent response when the button is pressed
• Replaces switches with loose action, sticking, or heat-discolored/burned terminals

• 1 push button switch

• Disconnect power before servicing to avoid electrical shock
• Access the console/control panel to reach the switch
• Note wire positions (take a photo) and transfer connectors one at a time; ensure firm, fully seated terminals
• Secure the switch in the panel (nut/clip as applicable), verify button action, then reassemble and test

This meter case assembly prepares the coin meter housing so the coin box and meter install correctly, helping restore coin-operated control and proper meter alignment. It fits the meter/meter case area on compatible commercial washers. What it does:

• Replaces a damaged or worn meter case housing that can prevent proper coin meter mounting
• Restores secure mounting and alignment for coin meter components
• Helps resolve symptoms like loose meter, poor coin box fit, or misaligned meter connections
• Works as the housing/assembly used where the meter and coin prep components attach

• Designed to be installed where coin meter housing mounts; follow the machine's service manual for exact placement
• Turn power off and disconnect the appliance before servicing to avoid electrical shock
• Inspect adjacent fasteners and mounting points; replace any stripped screws for secure fit

This appliance screw replaces a missing or damaged fastener to secure panels and brackets. With a 10B-16 thread and 0.34-inch length, it restores a tight fit to help reduce vibration, rattles, and loosening.

• Fastens sheet-metal parts, brackets, and covers in the appliance cabinet
• Helps maintain alignment and support of components subject to vibration
• Direct replacement for stripped, rusted, or missing hardware
• Can help resolve symptoms like loose panels, rattling noises, or gaps

• Disconnect power; shut off gas/water as applicable before servicing
• Start threads by hand in the original hole or clip to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping
• If the receiving clip/nut is damaged, repair or replace it for a secure hold