Parts for Speed Queen STGNCASP115TW01: Dispenser Assy Parts

This top cover weldment is the factory replacement panel that supports and protects the washer's upper cabinet area, restoring a secure, finished top surface and preventing damage to internal components. Ideal for repairing loose, bent, or damaged tops. What it does

• Replaces the welded lower section of the top cover assembly to restore structural support and proper fit.
• Protects internal components and wiring from debris and accidental contact.
• Helps stop rattling or movement caused by a damaged or warped top panel.
• Restores the cabinet surface for proper sealing and alignment with other panels.

• Disconnect power before starting any repair to avoid shock or injury.
• Basic disassembly of the cabinet top and removal of mounting fasteners required; follow OEM service manual for steps.
• Handle edges carefully — metal panels and weldments can have sharp edges.
• Reuse or replace any fasteners/clips as needed to ensure a secure fit and proper alignment.

This replacement detergent dispenser hose carries liquid detergent from the dispenser to the washer tub, restoring proper detergent flow and preventing leaks or dispenser buildup. Fits as the direct hose between the dispenser assembly and the wash tub. What it does:

• Routes detergent from the dispenser to the tub so detergent reaches the wash load
• Replaces cracked, kinked, clogged, or leaking dispenser hose
• Helps stop leaks that can occur under the dispenser or inside the cabinet
• Restores normal dispenser operation when the original hose is damaged or obstructed

• One detergent dispenser hose

• Disconnect power to the washer before beginning repair
• Turn off water supply and access the dispenser area per your model's service instructions
• Remove old hose clamps and routing carefully; install new hose with secure clamps and correct routing to avoid kinks

This is a stainless-steel #8 x 1/2" Torx screw used to secure panels and components on Speed Queen appliances. Stainless construction resists corrosion for reliable fastened connections in laundry equipment. What it does

• Secures console, trim, panels, and internal brackets where a #8 x 1/2" Torx fastener is specified.
• Replaces missing or damaged screws that can cause loose panels, rattling, or misaligned components.
• Stainless-steel construction helps prevent rust in wet or humid laundry environments.
• Small, common fastener for service and reassembly after repairs.

• One stainless-steel #8 x 1/2" Torx screw.

• Use the correct Torx driver size to avoid stripping the screw head.
• Tighten finger-tight then snug; avoid over-torquing which can strip threads or crack plastic.
• Disconnect power (and water if applicable) before working on appliance internals to reduce shock or injury risk.

This replacement dispenser handle restores a washer's detergent/bleach dispenser drawer to normal operation and appearance. Durable white finish matches original trim and lets you open and close the dispenser reliably. What it does:

• Replaces a cracked, broken or missing dispenser drawer handle so the dispenser can be opened and closed
• Restores proper grip and lever action for dispensing detergent or bleach
• Helps prevent leaks or product spillage caused by a loose or non-functioning handle
• Matches original white styling for a clean look on the control panel area

• One white dispenser handle

• Disconnect power to the appliance before beginning any repair
• Many installs are simple: remove the dispenser drawer or access panel to swap the handle; low-level hand tools may be required
• Handle clips or screws should be secured firmly but not over-tightened
• If you encounter any broken mounting tabs or hidden fasteners, stop and consult a detailed repair guide.