Parts for Speed Queen STGNCASP115TW01: Gas Valve / Igniter / Gas Conversion Kits-Gas Models Starting S#1908000001 Parts

This is an igniter and bracket assembly, and it is intended for use in dryers. This is a genuine replacement part made by Speed Queen. The igniter is connected to the dryer on the back of the appliance, and it is used to heat the drying tub. A new igniter and bracket assembly might be needed if the dryer is unable to reach the correct temperature. If the heat in the dryer seems inconsistent during any drying cycle the igniter might be bad and will need to be replaced. For this repair the user will need access to the back of the appliance. Be sure the dryer is completely powered down and cooled before attempting to repair. This is an OEM part sourced directly from the manufacturer, and it is sold individually. It is compatible with Dryers made by Speed Queen.

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

This appliance screw replaces a missing or damaged fastener to secure panels and brackets. With a 10B-16 thread and 0.34-inch length, it restores a tight fit to help reduce vibration, rattles, and loosening.

• Fastens sheet-metal parts, brackets, and covers in the appliance cabinet
• Helps maintain alignment and support of components subject to vibration
• Direct replacement for stripped, rusted, or missing hardware
• Can help resolve symptoms like loose panels, rattling noises, or gaps

• Disconnect power; shut off gas/water as applicable before servicing
• Start threads by hand in the original hole or clip to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping
• If the receiving clip/nut is damaged, repair or replace it for a secure hold

This packaged burner assembly supplies and directs the gas flame needed to heat a gas dryer's drum. Replacing a faulty burner assembly restores reliable ignition and helps the dryer produce consistent, usable heat. What it does:

• Houses the burner tube and pilot/orifice components that create and channel the gas flame
• Ignites and sustains the flame used to heat air flowing through the dryer
• Commonly replaced when the dryer won't heat, the burner won't ignite, or flame is weak/intermittent
• Works with the dryer's safety and control systems to shut off gas if ignition fails

• Turn off and disconnect both the electrical supply and the gas supply before beginning work
• Inspect and replace any gaskets or seals as needed; confirm all gas fittings are tight
• After installation, check for gas leaks and proper ignition; follow local codes and safety practices