Parts for Jenn-Air JES9900BCB: 03 - Control Panel / Top Asy Parts

Fix burners stuck on high or with no heat control. This infinite switch restores precise temperature adjustment. DIY-friendly repair in under an hour.

If your large burner won't heat or stay at the right temperature, the element switch likely needs replacement. Simple 10-15 minute repair with a screwdriver.

Indicator light that illuminates when functions are active on your range control panel. Replace if stuck on, dim, or fails to light. Verify fit by model number.

To order indicator light use WP903115.

Color: stainless steel. It measures about 2 inches in diameter.

Sheet metal pan head screw secures panels, brackets, and components to appliance cabinets. Replace missing, stripped, or corroded screws to restore fit.

Fix oven display errors, non-responsive buttons, or temperature control issues with this range control board. Moderate repair taking 30-60 minutes.

Range control knob installs on the control panel to adjust burner and oven settings. Replace if knob is cracked, broken, stripped, or illegible.

Burner not heating or 'Hot Surface' light stays on? This electric cooktop surface element is likely the fix. DIY-friendly, most installs take 15 minutes.

The Large Surface Element is an OEM component for Whirlpool ranges. As a key heat source, it withstands significant thermal stresses each use for cooking tasks. This surface element measures approximately 10” in diameter.

Over time, microfractures may accumulate in the ceramic glass from repetitive heating/cooling cycles. Mineral deposits also build up on the surface, reducing heat transfer effectiveness.

Symptoms involve:

• Inconsistent or diminished heat from the designated zone 
• Noticeable cracks, clouding or chips in the glass material
• Safety hazards if integrity is lost, exposing electrical/gas

The element is compatible also for select KitchenAid and Maytag appliances.

Replace your cracked, broken, or worn range control knob. Push-on design installs on the control switch shaft. Restores full functionality to your cooktop.

This is a replacement screw used to secure panels and components on compatible Whirlpool appliances, sold as a pack to replace multiple fasteners at once. It provides a simple way to restore missing or worn screws and stop rattles or loose trim. What it does

• Fastens appliance panels, trim, brackets or internal components
• Restores proper fit where screws are missing or corroded
• Helps eliminate vibration noise and loose parts
• Matches OEM fit for the listed part number when used in the intended locations

• Use the correct screwdriver or nut driver to avoid stripping the head
• Keep screws organized and install only where the OEM diagram specifies
• Disconnect power and follow appliance safety procedures before servicing
• Wear safety glasses and avoid over-tightening to prevent damage

Burner not heating? This surface radiant element sits beneath the glass cooktop and restores heat to a cold zone. Moderately difficult repair.

Element not heating or glowing? This surface heating element restores heat to your cooktop burner. Moderate DIY repair requires glass top removal.

Burner stuck on high or won't heat? This infinite switch controls electric cooktop burner temperature. Moderate DIY repair restores heat control.