Dryer Screws, Nuts, Washers

Size: 10 - 24 x 3/8

A single replacement screw fastener used to secure trim, panels, or internal components. Fits specific Frigidaire appliance locations to restore proper fastening and alignment where factory hardware is missing or damaged. What it does:

• Secures plastic trim, brackets, or metal panels in refrigerators and freezers
• Restores proper alignment and prevents rattling or loose parts
• Replaces stripped, corroded, or lost hardware to maintain appliance function
• Works wherever the original factory screw was specified

• One replacement screw

• Use the correct screwdriver or bit to avoid damaging the screw head
• Do not overtighten; snug until seated to prevent cracking plastic or stripping threads
• Replace only with the exact factory part for proper fit and function
• Unplug the appliance or turn off power first if working near electrical components

This is a replacement mounting screw used to secure panels, brackets, or components on compatible Whirlpool appliances. It restores proper fastening to reduce looseness and rattling and keep parts aligned for safe operation. What it does

• Fastens trim, panels, brackets or assemblies to the appliance chassis
• Restores secure attachment when original screw is missing, loose, or stripped
• Helps stop vibration-related noise and movement of panels or covers
• Supports correct alignment of components to prevent wear or interference

• Disconnect power to the appliance before beginning any service.
• Start threads by hand to avoid cross-threading; tighten snugly but do not overtighten.
• Keep removed screws organized so replacements go back to their original locations.

This is a genuine replacement screw used to secure appliance panels and components, restoring proper fit and reducing vibration or rattling. Simple, low-cost fastener that helps keep parts aligned and stable. What it does:

• Fastens panels, brackets, or trim to the appliance frame
• Restores secure connections that can cause buzzing, rattling, or loose trim
• Replaces missing or stripped hardware to prevent further movement or wear
• Works where the original OEM screw was specified for fit and compatibility

• Disconnect power before working on electrical appliances to avoid shock
• Use the correct size driver to avoid stripping the head
• Install by hand initially to ensure proper threading, then snug—do not overtighten
• Retain removed hardware and compare to the new screw for correct fit before final assembly

This spacer positions and secures components in place to maintain proper alignment and clearance. It helps reduce vibration and wear by keeping parts correctly spaced inside the appliance. What it does:

• Provides stable separation between panels, brackets or components to ensure correct fit
• Helps prevent rubbing, vibration noise, and premature wear caused by misaligned parts
• Used where a precise gap or mounting offset is required for proper operation
• Commonly installed during repairs or when replacing damaged mounting hardware

• Inspect surrounding mounting points and fasteners; replace any stripped or damaged hardware
• Use correct fastener torque and avoid over-tightening to prevent deformation
• Disconnect power to the appliance before working in or near electrical components

This is a 10-14 x 1.00 screw used to secure appliance panels and components. It provides a proper fit for threaded openings and restores fastener integrity after repairs. What it does

• Fastens panels, brackets and trim to the appliance frame
• Replaces missing or stripped screws that cause loose or rattling parts
• Secures components that require a 10-14 thread size with a 1.00" length

• Disconnect power to the appliance before servicing
• Use the correct screwdriver or driver bit to avoid cam-out and head damage
• Thread into matching 10-14 female threads only; do not force into incorrect or damaged holes
• Do not overtighten—stop when snug to avoid stripping threads or cracking panels