Dryer Screws, Nuts, Washers

Mounting screw for dryer assembly. Secures panels, brackets, or internal components. Replace if stripped, missing, or damaged during repairs.

Ground

Replacement mounting screw for dryer assembly. Secures internal components and panels. Order when original screw is stripped, missing, or damaged.

Red mounting screw for dryer assembly. Secures internal panels and components. Order replacement if original screw is stripped, missing, or damaged.

This is a hinge base screw used to secure a door hinge assembly so the door stays aligned and operates smoothly. It replaces a worn, missing, or damaged hinge screw to restore proper hinge fit. What it does:

• Secures the hinge base to the cabinet/frame to keep the door aligned
• Prevents door sagging, misalignment, or uneven gaps
• Stops loose-hinge noise or clunking during door movement
• Restores stable pivoting for smooth opening and closing

• One hinge base screw

• Disconnect power to the appliance and support the door before removing hinge hardware
• Use the correct screwdriver or bit to avoid stripping the screw head
• Thread carefully and do not overtighten to prevent damage to the hinge or mounting surface
• If other hinge components are worn or damaged, replace them as well for best results

This flat washer helps secure fasteners and distributes load to prevent damage where two parts join. It's a simple, durable replacement to restore proper fit and reduce movement at a bolted connection. What it does:

• Provides a flat bearing surface to spread pressure from nuts or bolts
• Helps prevent fasteners from digging into or deforming mating parts
• Reduces loosening from vibration or movement
• Can stop rubbing or binding that causes noise or premature wear

• One flat washer

• Power off and unplug the appliance before accessing internal components
• Replace the washer with an identical style and size to maintain fit and function
• Inspect mating fasteners and threads for damage; replace if worn
• Tighten fasteners to a snug fit—do not overtighten, which can cause distortion

This SCR 8-18 AB 1/2 is a replacement silicon controlled rectifier that restores proper power control to the appliance's control circuitry, helping the unit switch and regulate current reliably. What it does:

• Controls current flow in the appliance's power/control circuit for timed or regulated output
• Replaces a failed or intermittent SCR to stop erratic cycling, no-power, or control malfunctions
• Commonly used where electronic switching or phase control is required
• Helps restore stable operation when heating or motor circuits fail to receive proper control signals

• One SCR 8-18 AB 1/2 replacement component

• Disconnect power to the appliance before inspecting or replacing electrical components
• Observe ESD precautions and handle the SCR by its body; avoid touching leads
• Verify wiring and mounting orientation match the original part before final assembly